Parts for Ge PSB48LGRABV: 06 - Ice Maker & Dispenser Parts

Replace your refrigerator water filter every 6 months to maintain clean water and ice. Removes contaminants for fresh taste. Easy DIY install in minutes.

This authentic replacement part is an ice bucket assembly for freezers. The ice bucket assembly is the main container where ice is stored after being produced by the ice maker. Over time, an ice bucket can become cracked or damaged after excessive wear and tear. If the ice bucket is no longer secure, or visibly damaged to the point where it is unable to properly store ice, it will need to be replaced.To replace this part, start by opening the freezer door to locate the damaged ice bucket. After that, pull the old bucket out of its shelf by pulling it up and away from the freezer. Set the old bucket aside, and proceed to install the new bucket. Simply place it on its shelf and make sure it is set securely in place.This genuine OEM part is sold individually and is sourced directly from the manufacturer. It is compatible with General Electric, Hotpoint, RCA, and Sears/Kenmore brand refrigerators.

Self-tapping screw for refrigerator interior panels, shelves, or housings. Replaces lost, stripped, or damaged screws during repairs or reassembly.

Replace your refrigerator's ice bucket door cover if it's cracked, broken, or missing. This cover installs on the ice storage bin to keep ice fresh.

Ice not dispensing from your refrigerator? A faulty auger motor prevents ice from moving through the dispenser chute. Direct replacement part.

This cover cap protects and conceals the lever arm mechanism in your refrigerator. Replace if cracked, broken, missing, or no longer securely attached.

Ice maker not dispensing ice? The auger drive fork connects the motor to the auger that moves ice to the dispenser. Straightforward replacement part.

Special-purpose screw for securing refrigerator panels, brackets, and assemblies. Replaces missing or damaged fasteners to restore proper fit.

Tapping screw for dryer or refrigerator assembly. Replace this fastener if cracked, stripped, or missing during panel or component installation.