Parts for Bosch B22CT80SNP/01: Ice Maker Parts

This ice mold is the formed tray that holds and shapes ice inside the refrigerator's automatic ice maker. It restores proper ice formation so trays fill and release solid, usable cubes. What it does:

• Holds water while the ice maker freezes it into cubes
• Supports even freezing to help full molds form
• Allows the ice maker to eject cubes cleanly when harvested
• Addresses symptoms like small, misshapen, or absent ice production

• One replacement ice mold

• Disconnect power to the appliance before attempting service
• Remove any ice and thaw the area if frozen before swapping the mold
• Handle carefully to avoid damaging mounting tabs or sensors

Replacement water inlet valve that controls water entering the dishwasher so cycles fill correctly. Restores reliable fills and helps address no-fill, overfill or intermittent-fill issues when the original valve fails. What it does:

• Directs and meters incoming water into the wash chamber to achieve proper fill levels.
• Opens and closes to allow water during fill cycles; a failed valve can cause no water, intermittent filling, or extended cycles.
• Prevents uncontrolled water flow at the inlet when seals and valve components are intact.

• Disconnect electrical power and shut off the water supply before beginning any work.
• Access typically requires removing the lower access panel or toe kick; basic hand tools are usually sufficient.
• Inspect inlet hoses and seals during replacement and replace any damaged components to avoid leaks.
• After installation, restore water and power, run a short cycle, and check for proper filling and any leaks.

This replacement spray arm restores proper water distribution inside compatible dishwashers for better cleaning coverage and rinse performance. It replaces a worn, cracked, or clogged spray arm to help ensure dishes come out cleaner. What it does:

• Directs pressurized water to clean dishes and cookware during wash cycles
• Helps maintain even spray coverage across racks for improved wash results
• Replaces damaged, broken, or clogged spray arms that cause poor cleaning
• Can reduce unusual noises or wobbling if the original arm is loose or cracked

• Disconnect power and shut off water supply before servicing the dishwasher
• Remove racks and existing spray arm per manufacturer instructions to access mounting point
• Inspect spray arm bearing or support and clean any debris before installing the new arm
• Hand-tighten and test run a short cycle to ensure secure fit and proper operation

This automatic ice maker assembly forms and releases ice cubes into your refrigerator's bin, restoring steady ice production when the original unit fails. Install to resolve no-ice or incomplete harvest issues and keep ice ready when you need it.

• Freezes water in its mold and ejects cubes into the storage bin during each cycle
• Pauses production when the bin is full to prevent overflow
• Coordinates with the refrigerator control and water valve for proper fill and harvest timing
• Common symptoms include: no ice production, won't cycle/harvest, cubes jammed, or leaking/overfilling near the ice maker

• Disconnect power and turn off the water supply before servicing
• Remove the ice bin; unmount the old ice maker and unplug its connector; mount and connect the new assembly
• Align the fill tube with the ice maker's fill cup to prevent leaks
• Restore power and water; allow several hours (up to 24) for normal ice production to resume