Parts for Frigidaire FFHB2740PEDA: 09 - Ice Maker Parts

Routes water from the valve to the dispenser and ice maker. Replace if cracked, kinked, or leaking to restore proper flow and prevent water damage.

Ice bin filled with solid ice block? Cracked ice tray leaking water into bin? This ice maker assembly fixes freezing issues. 15-minute DIY install.

Ice maker freezing over or heavy frost buildup? This defrost thermostat controls your refrigerator's defrost heater. Moderate DIY repair with video guide.

Single mounting screw secures trim, panels, or brackets inside your refrigerator. Replace lost, stripped, or damaged screws to keep components firmly attached.

Molded support housing that mounts and protects internal refrigerator components. Replace if cracked, broken, or damaged to restore secure fit and alignment.

Ice buildup in fresh food section or around evaporator? This air handler housing kit stops warm-air leaks that cause frost and temperature swings. 30-min repair.

Factory fastener that secures panels, brackets, and internal components. Replace missing, stripped, or corroded screws to restore tight fit and eliminate rattling.

No water or ice from your refrigerator? A faulty water inlet valve often causes this. Easy DIY repair with basic tools in under 30 minutes.

Fix a cracked or missing control panel cover that exposes switches or causes misaligned knobs. This housing cover protects internal components and restores a clean finish.

Replacement cover that restores appliance appearance and protects internal components from dirt and damage. Installs in place of a worn, cracked or missing cover to keep controls and wiring safely concealed and the unit looking finished. What it does:

• Protects the control area and internal components from spills, dust, and accidental contact.
• Hides and secures wiring and mounting points to prevent snagging or tampering.
• Restores the appliance's finished look when the original cover is scratched, cracked, broken, loose, or missing.
• Helps reduce the chance of debris entering sensitive areas that can affect performance.

• One replacement cover.

• Disconnect power (unplug or shut off circuit breaker) before attempting any service.
• Basic hand tools are typically required; support the cover while removing fasteners to avoid dropped parts.
• Handle edges carefully to avoid cuts and to prevent scratching adjacent surfaces.
• Refer to the appliance's service manual or model-specific instructions for exact removal and reinstallation steps.

Secures tubes and wiring in your refrigerator. Replace if clips are broken or connections are loose. Confirm fit with your model number.

Mounting screw for refrigerator panels, handles, and internal components. Replace stripped, corroded, or missing screws to secure assemblies properly.

Small retainer clip that secures components, panels, tubes, or wires in place inside your refrigerator. Replace when worn, broken, or missing to restore fit.

Connects sections of water tubing inside your refrigerator. Replace this adapter if cracked, leaking, or popping off to stop drips and water damage.

Routes water from the valve to the dispenser and ice maker. Replace if cracked, kinked, or leaking to restore proper flow and prevent water damage.