Parts for Frigidaire FRFN2823AS2: Ice Maker Parts

Fix leaking or no water to ice maker and dispenser with this internal water supply tube. Direct-fit replacement for damaged refrigerator plumbing lines.

Restore ice production when your refrigerator stops making ice. This freezer-mounted ice maker assembly uses a twist-eject mechanism. DIY install in 30 minutes.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head

Replacement mounting screw for refrigerators, ovens, ranges, and cooktops. Secures interior panels, components, and trim. Needed when original is stripped, missing, or damaged during repair.

This triple-solenoid water inlet valve controls water flow to the ice maker and water dispenser in Frigidaire and Electrolux side-by-side and French door refrigerators. If the ice maker has stopped producing ice, water is leaking from the back of the refrigerator, or the dispenser has low or no water flow, a failed water inlet valve is a common cause. The valve requires at least 20 psi of water pressure to close properly - if pressure is adequate and the valve still leaks or fails to supply water, the valve itself is likely defective and should be replaced. Disconnect water supply and unplug the refrigerator before installation. Note the positions of the color-coded water lines before removing the old valve, and confirm all push-connect fittings are fully seated with retention clips in place after installing the new one.

Secures tubes and wiring in your refrigerator. Replace if clips are broken or connections are loose. Confirm fit with your model number.

Secures refrigerator grille or trim to cabinet, preventing rattles and gaps. Replace when broken or missing to restore proper panel alignment. Verify fit with your model number before ordering.

Small retainer clip that secures components, panels, tubes, or wires in place inside your refrigerator. Replace when worn, broken, or missing to restore fit.