Parts for Electrolux E36IC80ISS1: 03 - Induction Unit Parts

This is an electronic noise filter board that suppresses electrical interference generated by the range's components, preventing it from affecting the control board and other electronics. It is typically mounted near the power supply wiring inside the range. Replace this filter if you experience erratic control panel behavior, display flickering, or if the board shows visible burn marks or damage.

Cooktop won't heat or turn on? A blown thermal fuse is often the cause. This safety component protects against overheating. DIY-friendly repair.

Spacer for ranges and ovens. Maintains proper spacing between components. Replace if worn, cracked, or missing to ensure correct alignment and fit.

Replace a cracked or missing power board spacer in your range. This insulating bushing mounts between the control board and chassis for proper spacing.

Range won't turn on or display shows incomplete numbers? This electronic control board manages cycles and user inputs. Moderate DIY repair, 1-2 hours.

Specs: 10-32 X 0.375

Specs: 10-32 X 0.375

Motor making noise or loose? This motor mounting nut secures motors in refrigerators, ranges, and other appliances. Simple install takes 15 minutes.

This wiring harness routes power and signals between components so the appliance operates reliably. It restores proper electrical connections and helps resolve failures caused by damaged or loose wiring. What it does:

• Provides factory-style electrical connections between control, sensors, and motors
• Replaces frayed, burnt, or corroded wires that cause intermittent operation or loss of function
• Restores power and communication to affected components so controls and motors respond correctly
• Helps stop shorts or open circuits that can prevent the appliance from running

• Disconnect power (unplug or switch off breaker) before servicing to avoid shock or injury
• Route and secure the harness following the original wire paths; avoid pinching or contact with hot surfaces
• Inspect connectors and terminals; replace the harness if insulation or contacts are damaged

Motor making noise or loose? This motor mounting nut secures motors in refrigerators, ranges, and other appliances. Simple install takes 15 minutes.

This wiring harness routes power and signals between components so the appliance operates reliably. It restores proper electrical connections and helps resolve failures caused by damaged or loose wiring. What it does:

• Provides factory-style electrical connections between control, sensors, and motors
• Replaces frayed, burnt, or corroded wires that cause intermittent operation or loss of function
• Restores power and communication to affected components so controls and motors respond correctly
• Helps stop shorts or open circuits that can prevent the appliance from running

• Disconnect power (unplug or switch off breaker) before servicing to avoid shock or injury
• Route and secure the harness following the original wire paths; avoid pinching or contact with hot surfaces
• Inspect connectors and terminals; replace the harness if insulation or contacts are damaged

Phillips pan head screw for securing panels and components in appliances. Replace missing, stripped, or corroded screws during repairs or maintenance.

Phillips pan head screw for securing panels and components in appliances. Replace missing, stripped, or corroded screws during repairs or maintenance.