Inglis Dishwasher Gasket & Seal
Genuine Whirlpool part
By: Whirlpool
Part Number: 285448A
This factory washer is used in appliance assemblies to distribute load under a fastener and maintain a secure, accurate fit. Replace a missing or damaged washer to restore proper stack-up and reduce vibration, noise, or loosening.
- Distributes load and provides proper spacing in the fastener assembly
- Helps keep bolts, screws, or nuts tight to minimize vibration and rattling
- Direct replacement when the original washer is worn, bent, cracked, or missing
- Typical signs include loose panels/brackets, recurring looseness after tightening, or new vibration after service
What's included: 1 washer Install notes:
- Unplug the appliance; shut off water supply if working near hoses or valves
- Note the original hardware stack-up and reassemble in the same order
- Inspect mating surfaces and companion hardware; replace any damaged parts
- Tighten fasteners snugly per service guidance; avoid overtightening
Do-It-Yourself Stories from Customers like You
Wash machine water inlet valve Larry E. • Coleharbor , ND • February 18, 2017
Watched a video online, the project took about 20 minutes, went well, parts fit good, the video was very helpful in getting the wash machine up and running.
Read more
More
$5.34
- Compare At:
-
$6.35
- You Save:
-
$1.01