Parts for Ge ZSC2202NSS02: 05 - Interior Parts (2) Parts

Replaces cracked or broken microwave turntable ring assembly. Supports the glass tray as it rotates. Includes three plastic wheels that commonly fail.

Replaces the center coupler shaft that connects your microwave's motor to the glass tray. Order a new shaft if yours is cracked, worn, or broken.

Replace your cracked, broken, or missing microwave glass tray. This rotating tray sits on the turntable support to hold food during cooking and heating.

This genuine oven rack restores interior cooking space and provides a stable, ventilated shelf for cookware. It replaces worn, bent, or missing racks so pans slide in and out smoothly for even cooking. What it does:

• Provides a sturdy support surface for cookware and bakeware
• Keeps food elevated for even air circulation and consistent baking
• Replaces damaged or warped racks that can cause uneven cooking or sticking
• Slides on existing oven rack guides for easy positioning

• Remove all oven shelves and allow the oven to cool before installing
• Slide the rack into the oven on the designated rack supports until fully seated
• No special tools required; check that the rack moves smoothly and sits level
• For safety, avoid leaning on racks or using them to support heavy loads beyond the oven's capacity

This flat metal tray is a replacement nonstick oven tray that gives you a flat cooking or drip surface for baking and roasting. It restores a level surface for pans and helps contain spills for easier cleanup. What it does:

• Provides a flat, rigid surface for baking, roasting, or catching drips beneath racks
• Restores proper fit when original tray is bent, warped, or missing
• Helps reduce food contact with oven floor and collects spills to prevent messes
• Nonstick finish eases cleanup when coating remains intact

• Install on the oven rack or support as shown in your owner's manual; ensure it sits flat before heating
• Allow tray to cool before handling to avoid burns
• Do not use abrasive pads or metal utensils on the nonstick surface to avoid damaging the coating
• Inspect coating for chips or flaking; replace if coating is compromised to avoid contamination

This nonstick metal broil pan grid provides a sturdy cooking surface for broiling, letting juices drain away for better browning and easier cleanup. Replaces worn or warped grids to restore consistent broiling performance. What it does:

• Holds food above the broil pan so heat circulates for even browning and searing
• Allows grease and drippings to drain away to reduce smoking and flare-ups
• Provides a nonstick surface to help prevent food from sticking and simplify cleanup
• Restores proper fit and stability when an original grid is bent or damaged

• Allow the oven and parts to cool completely before removing or installing the grid
• Slide the grid into the broiler pan or oven rack position as shown in your oven manual
• Clean with warm, soapy water; avoid harsh abrasives that can damage nonstick finish
• Follow all oven manufacturer safety instructions when operating the broiler