Parts for Ge UVM9125ST2SS: Interior Parts

Replace a cracked or missing microwave turntable to restore even cooking and proper food rotation. This tempered glass platter is easy to install.

This microswitch senses the microwave door position and controls the safety interlock circuits. Replacing a worn switch restores proper start/stop behavior so the oven only runs when the door is fully closed.

• Detects door open/closed status to enable or disable cooking
• Part of the safety interlock system that stops operation if the door opens mid-cycle
• Replace if the switch fails a continuity check or shows heat or terminal damage

• Disconnect power before service; microwave capacitors can retain a dangerous charge
• Note wire positions and move them to the same terminals on the new switch
• Ensure the door latch cleanly actuates the switch; test operation before reassembly

A replacement thermostat that monitors and regulates appliance temperature to restore consistent heating and more accurate temperature control. Use this thermostat when the original fails, causes inconsistent temperatures, or heating cycles behave erratically. What it does:

• Senses internal temperature and signals the appliance's heating system to maintain set temperatures.
• Helps stop persistent over- or under-heating and reduce wide temperature swings during cycles.
• Commonly used when an appliance won't reach or hold the correct temperature or cycles on and off too frequently.
• Works as a temperature-control component; does not include related sensors, switches, or wiring harnesses unless listed.

• Disconnect power to the appliance before servicing to avoid shock or injury.
• Allow the appliance to cool completely; handle sharp sheet metal and hot surfaces with care.
• Replace only with the correct part number; secure terminals and wiring per the appliance's wiring diagram.