Need Help?
Call or text
Fix burners that won't light or spark inconsistently with this cooktop spark igniter switch. Restores reliable ignition on gas burners. Takes 15 minutes to install.
Replaced igniter under each burner knob. Used needle nose pliers to remove the electrical connections (2) of the igniter then slipped it off the gas valve shaft. Replaced with new igniter (click in place) and replaced electrical connectors. Took about 15 minutes to complete. Read more
Fixes burners that won't ignite, constant sparking when turned off, or igniters that spark when other burners are on. Direct replacement, basic tools needed.
I replaced the burner switches, since we had been having trouble with specific burners igniting unless another burner was tuned on. Then I replaced the spark module since the flame and the burner being turned off were not being detected and burners would not re-light if the flame went out. Read more
Fix a downdraft fan that won't turn off, runs sluggishly, or fails to start with this cooktop fan switch. DIY-friendly repair with basic tools.
This replacement part looks nothing like the original because the original is two parts, the replacement is one part. The original has a switch with 3 wires coming out of it that go into a "block" screwed to the bottom tray. And this "block" has 2 wires that come out of it going to the fan. With the replacement, the block is eliminated and the 2 wires go directly to the switch. Easy install. Read more
Fix a burner that won't heat, sparks continuously, or doesn't respond to knob settings. This switch restores proper temperature control. 30-minute DIY repair.
If your cooktop burner won't heat, stays on one setting, or heats erratically, this control switch regulates power to restore proper temperature selection.
Replaced switch on the gas valve. Read more
Exhaust fan won't turn off or stuck on? This rocker switch restores reliable blower control. Simple 5-minute fix—just disconnect wires and snap in new.
SSVD48600Pon finally popped the control panel loose from the top of the stove. Took some manipulation as the stove is more than 20 yrs. old With a screwdriver finally popped the switch loose. Applied the new switch. Popped the top back to the control panel. Put the screws back in and everything was back to normal. Read more
Usually ships within 4 - 14 days
Replace a broken rocker switch causing control issues on your range or cooktop. Simple snap-in installation fixes non-responsive buttons and controls.
A new ignitor was installed, and a new light switch was installed Read more