Thomas S Hanover , MA November 29, 2014 Appliance: Model LG WM2277HW Le error on lg wm2277hw Replaced Hall sensor and wiring harness. Very simple fix. So far, so good...! Read More... 2 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers, Socket Set
Mark S La Palma , CA July 30, 2014 Appliance: LG Washer WM0532HW Le code on ten year old wm0532 would fill but not rotate consistently or at all unplugging would allow it to drain when empty With some basic tools and some information off your site, I was able to replace this wire harness with no problems. It was super easy and will be using you guys again as needed in the future. Thank you! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Socket Set
Lee B Blaine , WA February 05, 2015 Appliance: LG Washer WM2277HW Le error code With sensor part ordered the video was very useful and the part fixed my issue no problems! Read More... 1 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Socket Set
James D Pueblo , CO April 10, 2021 Appliance: LG Laundry Center WM3997HWA Le error code Unplug machine. Remove back panel and ground screw, remove the drum, remove the coil and electrical connections. Cut zip tie at the bottom, remove the plastic wrapper and electrical connections, remove clips holding harness in place, remove and replace harness and rotor position sensor, put back together. I used 12v impact with 17mm for the center nut. 12v ratchet small extension 10mm for coil, small flathead to help remove connections and sensor, 12v impact with Phillips bit for the back panel, and snips for the zip tie. Have a zip tie with you to replace it Read More... Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Socket Set
Paul C Mullica Hill , NJ November 07, 2020 Appliance: Model WM3570WHA LG front loader le code. After googling the error, the recommendation was to replace both the rotor position switch sensor and motor wiring harness. Appliance Parts Pros was awesome, ordered the parts on a Friday morning and they arrived Saturday afternoon the next day allowing me to fix the washer the same weekend. Since this was the second fault (the drain pump needed to be replaced 3 weeks earlier) I wasn't sure if it was the board or not. The repair was simple only needing to take off the back cover and a few bolts. Read More... Do-It-Yourself Rating: Repair Time Estimate: 30-60 minutes Tools: Screwdrivers, Socket Set