Thomas K Ball Ground , GA June 27, 2015 Appliance: LG Refrigerator LFX25960TT Evap fan on refriderator was making horrible growlin noise Ordered parts, removed top tray in freezer, popped the back inside freezer panel out removed and replaced fan, dampers and fan housing. Took about 15 minutes. Read More... 61 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Nancy V Newport Beach , CA November 06, 2015 Appliance: Model 795.77553600 Refrigerator light was buring constantly generating excessive heat (2 60 watt bulbs) and melting plastic parts Was able to diagnose problem at AppliancePartsPros.com by entering the model #. This is apparently a common problem with this Refrigerator Replaced Light Socket Assembly, Lamp Reflector, Lamp Case and Lamp Cover. Also replaced the main circuit board (not sure if this was necessary). The wiring on the Light Socket Assembly was different than the original, so it was a bit confusing how to assemble it, and no screws were provided to attach it to the Lamp Reflector - figuring this out took most of my time, otherwise it would have been 45 minutes. I also replaced the bulbs with new LED bulbs. By the way after ordering the necessary parts, I checked prices at Sears.com - saved approximately 20% by buying at Appliance Parts Pros. Placed order on Sunday afternoon, parts were delivered on Tuesday afternoon. Read More... 25 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 1-2 hours Tools: Screwdrivers
Adolfo B Weston , FL December 31, 2016 Appliance: LG Refrigerator LFX25960ST The refrigerator lights on 24/7/365 situation ...after our refrigerator stopped working one of these mornings, I googled the symptom and was steered to a page where I was able to determine the possible culprit. To verify it, I left my cel recording inside and saw that the light stayed on. I was then directed to ALLPARTSPRO.COM, and was able to chat with a Rep, and after a short explanation told me to replace just the "push switchs"; so ordered them, plus the "light lens" and "cover", which had all melted for continuous lighting spanning over a 2 yrs period, at least (bulbs were of 60w ea). While parts arrived, I put a toothpick inside each switch to keep them activated, and removed melted parts and sockets. Once parts arrived, installation was a bliss, and all went back to normal almost immediately. I also replaced the bulbs with 2 LED 25w bulbs. I'm always going back to ALLPARTSPRO.COM for future help and parts, thanks! ;-]# Read More... 12 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Robert H Ramona , CA November 24, 2014 Appliance: Model KENMMORE ELITE 795.77543600 Refer lights stuck on overheated & melted light fixture base & lens refer unable to maintain temp as result Replaced control board with updated design that has higher amperage refer light relay. Replaced melted fixture parts. Read More... 11 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: 15-30 minutes Tools: Screwdrivers
Roger B Grove , OK May 04, 2020 Appliance: Model 775.775546000 No lights sockets brown. With the advice of Appliance Parts Pros on how to replace the parts. Read More... 6 People found this story helpful Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes Tools: Screwdrivers