Parts for Ge PTD700LSN2SS: Lower Door Parts

Replace your range's badge assembly if the original is cracked, broken, or missing. This decorative nameplate installs on the control panel area.

This stainless outer left lower-door hinge replaces a worn or damaged hinge to restore proper door alignment and smooth opening on compatible refrigerators. Durable finish matches stainless doors and resists everyday wear. What it does:

• Secures the refrigerator lower door to the cabinet and guides its pivot motion
• Restores proper door alignment to prevent sagging or gaps
• Eliminates uneven or noisy door movement caused by a damaged hinge
• Helps the door close flush to maintain the fresh seal and consistent cooling

• One outer left lower-door hinge

• Disconnect power and remove food from the door area before starting work
• Support the door securely while removing and installing the hinge to prevent dropping or damage
• Basic hand tools required; follow manufacturer's assembly order and fastener locations
• Inspect mating hinge components and seals during reassembly; replace any damaged parts

This upper left door hinge mounts at the top corner of the appliance door to support smooth opening and maintain proper door alignment. Replaces a worn or damaged hinge to help the door close squarely and reduce sag or uneven gaps. What it does:

• Provides pivot support for the upper left corner of the door so it opens and closes correctly
• Restores proper door alignment and helps prevent rubbing, sagging, or uneven sealing
• Replaces bent, cracked, or corroded hinges that cause noisy or difficult door movement
• Works with the existing hinge pin and mounting hardware to secure the door in place

• One upper left door hinge

• Install with power to the appliance turned off and disconnected from the power source
• Retain and reuse original mounting screws unless replacement hardware is specified
• If door sag persists after installation, check lower hinge and door strike for related wear

Replace your wall oven's door window pack assembly if the glass is cracked, broken, or scratched. Installs in the door frame for safe viewing while cooking.

10-18 x 3/4 inch Torx T20 screw secures control panels, trim pieces, and internal components in wall ovens. Replaces missing, stripped, or damaged fasteners.

Stainless steel #8-18 x 5/8 inch oval head screw secures panels, brackets, and trim on refrigerators. Replaces missing or damaged fasteners.

Hex head machine screw with 10-32 thread, 1-3/4 inches long. Secures brackets, panels, and internal oven components. Replace missing or stripped screws.