Parts for Ge ZET857BB2BB: 03 - Lower Oven Parts

This is a replacement trim piece that fits around the oven bake element to restore a finished appearance and help secure the element assembly. It replaces a damaged, bent or missing trim so the element mounts cleanly and safely. What it does

• Provides a finished trim around the bake element opening to restore oven appearance
• Helps hold the bake element in its proper position and alignment
• Covers gaps or sharp metal edges left by a damaged or missing trim
• Common symptom: visible damage, missing trim, rough or sharp edges around the element area

• One replacement bake element trim

• Disconnect power to the range before any service to avoid electrical shock
• Access typically requires lowering or removing the oven door and pulling the oven cavity forward; keep track of fasteners
• Handle metal trim carefully to avoid cuts; use gloves as needed
• If the bake element is loose or damaged, inspect the element and mounting hardware and replace separately if required

This ring-style convection heating element mounts around the fan at the back of the oven and supplies heat for convection cooking. Replacing a failed element helps bring back even air heating and consistent convection bake performance.

• Provides the heat source for convection bake/roast by warming air circulated by the fan
• Helps maintain set temperature and more even results in convection mode
• Common failure signs: no heat in convection while the fan runs, slow or incomplete preheating, uneven baking, visible breaks/blisters, or an open circuit on a continuity test
• Designed to cycle under control of the oven's sensor and electronic controls

• Disconnect power at the breaker or unplug the appliance before servicing
• Access may be from the rear of the appliance or by removing the interior panel over the convection fan, depending on the model
• Label and support the two element leads to keep them from retracting into the cavity; ensure terminals are fully seated
• Reuse existing mounting hardware; avoid bending the new element and verify it doesn't contact the oven cavity

This seal for the front frame creates a tight barrier between the oven door and frame to help retain heat and reduce smoke or odor escape. It restores a proper door seal to improve cooking performance and safety. What it does:

• Replaces worn, torn, or deformed front-frame gasket that allows heat or smoke to leak from the oven cavity
• Helps maintain consistent oven temperatures for more even cooking and baking
• Reduces heat transfer to surrounding cabinetry and surface areas
• Stops drafts, burning odors, or visible gaps around the door edge

• One seal for the front frame

• Disconnect power and let the appliance fully cool before attempting service
• Inspect orientation and seating before final installation; some models require door removal for access
• Use proper tools and gloves to avoid cuts; ensure seal is fully seated and continuous around the frame