Parts for Ge GTS18GTHFRBB: Machine Compartment Parts

Fiberglass insulation sleeve for refrigerator tubing. Replaces worn, damaged, or missing sleeves that protect refrigerant lines and reduce noise.

This condenser strap assembly secures the condenser coil to the refrigerator chassis, helping keep the coil stable and reduce vibration or contact with nearby components during operation. It's a simple replacement that restores proper condenser mounting. What it does:

• Holds the condenser coil firmly in place to prevent movement or rubbing against the cabinet
• Helps reduce rattling or vibration noises caused by a loose condenser
• Prevents wear or damage to the condenser from excessive movement
• Supports proper airflow clearance by maintaining correct condenser positioning

• Disconnect power to the appliance before beginning any repair.
• Use basic hand tools; support the condenser when removing and installing the strap to avoid bending the coil.
• Inspect surrounding components and fasteners; replace any damaged clips or screws as needed.

Secures dishwasher panels, brackets, and internal hardware. Replace this hex-head screw if stripped, missing, or corroded to restore proper assembly.

Replaces the rear access cover panel on your refrigerator cabinet. Restores finished appearance and shields components from dust. Order if cracked or missing.

Fix intermittent or failed component operation caused by damaged wiring. This harness assembly restores proper signal and power routing in your refrigerator.

Fix a noisy or broken condenser fan blade in your refrigerator. Common DIY repair that typically takes 20-30 minutes. Includes step-by-step video guide.

Replace missing or stripped dishwasher mounting screws. Secures internal components and panels. Essential hardware for reassembly after repairs.

Refrigerator not cooling or freezer not cold enough? The compressor circulates refrigerant to maintain proper temperature. Expert-level repair.

Provides start and run voltage to the compressor. Replace if cracked, damaged, or failing. Installs near the compressor at the bottom of the unit.

Refrigerator not cooling properly? This condenser coil restores heat dissipation when the original is damaged or corroded. Moderate DIY install.

Fix a refrigerator that clicks but won't cool by replacing the compressor start device. This relay and overload assembly helps start the compressor reliably.

Rubber grommet that mounts and cushions the compressor on your refrigerator or freezer. Replace if cracked, worn, or causing vibration noise from unit.

Retainer clip secures components inside your refrigerator. Replace if broken, loose, or missing to prevent rattling and ensure proper part alignment.

Refrigerator not cooling properly? This condenser support bracket secures the condenser coil in place to restore stable cooling performance.