Parts for Lg LBNC12551V: Main 1 Parts

A small replacement hinge cap that covers and protects the door hinge pivot on compatible LG appliances, restoring a finished look and keeping dirt out of the hinge area for smoother operation. What it does

• Covers the exposed hinge pivot to protect it from dust, grime and accidental contact
• Helps keep the hinge pivot area clean to reduce binding and noise over time
• Restores the original appearance where a hinge cap is cracked, missing or worn
• Compatible hinge cap replacement for one door hinge position

• High-level replacement; usually snaps or slides onto the hinge pivot—no special tools typically required
• Remove power from the appliance and support the door before removing or installing hinge components to avoid injury or damage
• Inspect hinge and surrounding components for wear while replacing the cap; replace any damaged hinge hardware as needed

Replaces cracked or missing plastic trim covering the door hinge area. Snaps into place to restore appearance and prevent dirt buildup.

Refrigerator not cooling or display not working? This main control board manages electrical functions. Moderate DIY repair restores cooling control.

Secures and pivots your bottom refrigerator door for smooth opening and closing. Replace when door sags or seals unevenly. Verify fit with your model number.

Replacement door stopper for bottom-mount refrigerators. Prevents door from overextending and protects hinges. Replace if cracked, broken, or missing.

Replacement door stopper for bottom-mount refrigerators. Prevents door from opening too far and protects hinges. Needed when original is cracked or missing.

Drain tray assembly that collects defrost water beneath your refrigerator. Replace if the original tray is cracked, damaged, or missing to prevent leaks.

Center hinge assembly provides the pivot point for refrigerator doors to swing and stay aligned. Replace when doors sag or don't seal properly. Verify fit.

Replaces worn upper door hinge to restore smooth pivoting and proper alignment. Install when door sags, misaligns, or won't seal. Confirm fit with model.

Seals the refrigerator door to maintain proper temperature and energy efficiency. Replace when worn or damaged to reduce air leaks and improve cooling.

This name plate is the exterior emblem that mounts to the appliance's front panel. It replaces a missing, cracked, or faded badge to restore a clean, factory look and cover the designated trim area.

• Attaches to the outer panel to display brand/series identification
• Restores a finished appearance where the original emblem sits
• Direct replacement for a lost, damaged, or worn badge
• Typical symptoms: missing emblem, loose or broken tabs, peeling, or discoloration

• Disconnect power before servicing the appliance
• Carefully remove the old emblem; release any tabs from behind or peel away remaining adhesive
• Clean and dry the mounting surface; remove all residue for best fit
• Align with the recess/holes and press evenly until fully seated