Parts for Frigidaire FFEC3024PSA: 03 - Main Top / Surface Units Parts

This Main Top Assembly replaces the upper cooktop surface on compatible electric ranges, restoring a secure, flat cooking area and properly seating burner elements and control components for safe everyday use. What it does:

• Provides the finished cooktop surface that supports burner elements and pans.
• Secures burner receptacles and element mounts to maintain proper alignment.
• Helps prevent heat and spills from reaching underlying components.
• Commonly replaced when the top is warped, cracked, dented, or no longer holds burners snugly.

• One Main Top Assembly

• Disconnect power to the range at the breaker before beginning service.
• Handle carefully — edges may be sharp and the finish can scratch; use gloves and a soft surface.
• You may need to remove burners, knobs, and retaining screws to lift off the old top and align the new one.
• Secure all fasteners; test burners after reconnecting power.

This oven bake element heats the oven cavity so food cooks and bakes properly. Replacing a worn or broken element restores consistent heat for even baking and broiling. What it does:

• Converts electrical power into heat to warm the oven interior during bake and broil cycles
• Replaces a damaged or open element that can cause the oven to not reach temperature or cook unevenly
• Works with the oven's control system to provide steady, distributed heating
• Common symptom: oven won't heat, heats very slowly, or produces uneven cooking results

• Disconnect power at the breaker before starting any repair
• Allow the oven to fully cool and wear gloves to protect against sharp edges
• Remove the oven bottom or access panel as required, disconnect element wiring, and secure the replacement element in the original mounting
• Reconnect power and perform a short test bake to ensure proper operation

This mounting bracket secures and supports internal appliance components to keep assemblies aligned and stable. It restores proper fit and reduces vibration for smoother, quieter operation. What it does:

• Provides a secure mounting point for internal panels or assemblies
• Keeps components aligned to prevent rubbing, rattling, or wear
• Reduces vibration and movement during normal operation
• Helps maintain proper door/panel fit and function when used where specified

• Disconnect power (unplug appliance or shut off breaker) before starting any repair
• Basic hand tools are typically required; access may require removing exterior panels
• Handle edges carefully; wear gloves and eye protection to avoid injury
• Follow model-specific instructions for correct placement and fastener torque

These are replacement countertop mounting screws that secure the appliance to the countertop or cabinet, restoring a stable, flush fit and preventing movement or gaps. Sold as a 2-pack for quick, direct replacement. What it does

• Secures the appliance countertop or trim to the cabinet or counter to keep the unit from shifting.
• Helps eliminate rocking, gaps, or uneven alignment caused by missing or loose mounting screws.
• Restores proper fit and finish where original mounting hardware has been lost or damaged.
• Works with factory mounting points and standard driver heads for straightforward replacement.

• Two countertop mounting screws.

• Use the correct-size driver to avoid stripping the screw head.
• Tighten until snug; avoid over-tightening which can strip threads or damage the cabinet/countertop.
• Keep original brackets and hardware; replace only the missing or damaged screws as needed.

Size: 6-20 x 0.312 inch.