Parts for Kenmore 790.42492402 (79042492402, 790 42492402): Maintop Parts

Burner won't heat or heats unevenly? This coil-style surface heating element restores reliable heat to your cooktop. Direct swap-in replacement.

Oven not heating or baking unevenly? This bake element heats the oven cavity during bake cycles. Moderately easy DIY repair restores consistent baking.

This main top assembly is the upper cooktop panel that provides a finished surface and support for surface elements and controls. It restores the appliance's cooking surface appearance and stability for safe operation. What it does:

• Replaces a damaged, warped, or cosmetically worn cooktop top to restore a flat, stable surface
• Supports surface heating elements and aligns openings for burners and control hardware
• Helps prevent heat and spills from reaching internal components when properly installed
• Addresses symptoms such as visible damage, looseness, or improper alignment of burners and control interfaces

• One main top assembly

• High-level task: remove power, detach burner components and control fascia as needed, then unfasten and lift out the old top before installing the new panel
• Safety first: disconnect electrical power at the breaker or unplug the appliance before any service
• Handle with care to avoid scratching the finish and to protect connected wiring and components

Replace cracked, rusted, or stained drip pans under your range burners. Catches spills and protects cooktop. Easy snap-in installation, no tools needed.

Chrome drip pan installs beneath range burner elements to catch spills and drips. Replaces cracked, rusted, or worn pans for a clean cooktop appearance.

This clip secures the appliance's terminal block to the chassis, keeping wiring stable and preventing strain on electrical connections. It's a small, durable mounting clip used where the terminal block needs a fast, reliable hold. What it does:

• Holds the terminal block firmly to the appliance frame to reduce wire movement and wear
• Helps maintain safe, stable electrical connections by preventing strain on terminal wires
• Prevents the terminal block from shifting during use or service
• Compatible with standard terminal block locations that use a push-in or snap-mount clip

• One terminal block mounting clip

• Always disconnect power before accessing or servicing electrical components
• Remove access panels and locate the terminal block; clip typically snaps into a chassis slot or aligns with an existing mounting boss
• Handle wiring and terminals gently to avoid loosening connections; verify all wires are secure after reinstall

Note: Quantity of two brackets

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

This is a replacement mounting screw used to secure appliance panels, brackets, and components. Replacing worn or missing screws restores proper fit and reduces rattles or loose parts for safe, stable operation. What it does:

• Secures panels, brackets, trim, or small components in place
• Helps eliminate rattling, vibration, and loose or misaligned parts
• Restores proper fastening after maintenance or part replacement
• Matches the appliance's original fastener style for correct fit

• Disconnect power to the appliance before servicing to avoid shock or injury
• Use the correct driver bit to avoid stripping the head
• Do not overtighten; snug until secure to prevent thread or component damage