Parts for Dcs CS-366SS 70015: Manifold Parts

This igniter switch mounts on the burner valve shaft and completes the ignition circuit when you turn the knob, causing the burners to click and light. Replacing a faulty switch restores dependable ignition and can stop nuisance clicking.

• Closes the ignition circuit when a control knob is turned
• Sends power to the spark module to generate burner spark
• Common symptoms include no clicking/spark when a knob is turned or continuous clicking after the burner lights

• Disconnect electrical power and shut off gas before servicing
• Remove the control knob and front panel/trim as needed to access the valve and switch
• Move wires from the old switch to the new one one at a time; orient the switch correctly on the valve shaft
• Reassemble, restore gas and power, then test burner ignition

This is a 8-32 x 1-inch Torx flat-head screw used to secure panels and components on compatible appliances. Durable hardware replacement that restores proper fastening and reduces rattles or loose parts. What it does:

• Fastens panels, brackets, and internal components where an 8-32 x 1 Torx flat-head screw is specified
• Restores secure mounting to stop vibration, rattling, or misalignment caused by missing or worn screws
• Matches OEM thread size and head style for proper fit in specified mounting holes
• Suitable for metal-to-metal and sheet-metal fastening in appliance assemblies

• 10 8-32 x 1-inch Torx flat-head screws

• Use the correct Torx driver for a snug fit; avoid stripping the head
• Hand-start screws to ensure proper alignment before final tightening
• Do not overtighten; snug until secure to avoid thread or component damage
• Disconnect power and follow appliance safety procedures before servicing