Parts for Dcs RGS-366: Manifold Parts

This igniter switch mounts on the burner valve shaft and completes the ignition circuit when you turn the knob, causing the burners to click and light. Replacing a faulty switch restores dependable ignition and can stop nuisance clicking.

• Closes the ignition circuit when a control knob is turned
• Sends power to the spark module to generate burner spark
• Common symptoms include no clicking/spark when a knob is turned or continuous clicking after the burner lights

• Disconnect electrical power and shut off gas before servicing
• Remove the control knob and front panel/trim as needed to access the valve and switch
• Move wires from the old switch to the new one one at a time; orient the switch correctly on the valve shaft
• Reassemble, restore gas and power, then test burner ignition

The Oven Light Switch is an OEM part for Fisher & Paykel ranges. It serves as the switch that activates and controls power to the interior oven light.

The light switch is designed to operate seamlessly with the range control panel, allowing users to conveniently toggle oven lighting on and off as needed. This facilitates visibility and ease when accessing the oven cavity.

Symptoms of a defective light switch include:

• The oven light fails to illuminate when the oven door is opened
• Flickering or intermittent oven light functionality
• The light remaining stuck in the "on" position
• The switch knob feeling loose, unstable, or faulty

This is a 8-32 x 1-inch Torx flat-head screw used to secure panels and components on compatible appliances. Durable hardware replacement that restores proper fastening and reduces rattles or loose parts. What it does:

• Fastens panels, brackets, and internal components where an 8-32 x 1 Torx flat-head screw is specified
• Restores secure mounting to stop vibration, rattling, or misalignment caused by missing or worn screws
• Matches OEM thread size and head style for proper fit in specified mounting holes
• Suitable for metal-to-metal and sheet-metal fastening in appliance assemblies

• 10 8-32 x 1-inch Torx flat-head screws

• Use the correct Torx driver for a snug fit; avoid stripping the head
• Hand-start screws to ensure proper alignment before final tightening
• Do not overtighten; snug until secure to avoid thread or component damage
• Disconnect power and follow appliance safety procedures before servicing

This 1/2" shut-off valve stops or restores water flow to the appliance, letting you isolate the supply for repairs or to stop leaks quickly. It's a direct-replacement service valve used on compatible Fisher & Paykel units. What it does:

• Controls water flow to the appliance supply line so you can turn water on or off at the appliance.
• Helps isolate the appliance for maintenance, repair, or replacement of hoses.
• Common symptom: water continues to flow or cannot be shut off at the appliance supply.
• Common symptom: leaking or dribbling at the supply connection that requires valve replacement.

• Turn off the household water supply and relieve pressure before replacing the valve.
• Use appropriate plumbing tools and thread sealant or tape where required; avoid over-tightening fittings.
• Inspect supply lines and fittings for damage and replace if corroded or worn.