Parts for Whirlpool SF302BSKW0: 03 - Manifold Parts

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Factory replacement screw that secures appliance components and hardware. Use it to replace a missing, stripped, or corroded fastener to restore a tight, rattle-free fit and help prevent loosening or damage from vibration.

• Fastens brackets, panels, or internal parts at the original mounting points
• Replaces worn or missing hardware to correct loose or misaligned components
• Helps reduce vibration-related noise and movement
• Matches the original thread and length specified for the application

• Disconnect power; shut off water or gas if applicable before servicing
• Compare to the original for thread and length match before installation
• Start threads by hand to avoid cross-threading; tighten snugly—do not overtighten
• Reuse any original spacers/washers if present; replace if damaged

This is an inverted flare nut with 3/8-24 UNF threading used on gas tubing connections in a range or oven. It creates a secure, leak-free seal where gas supply lines connect to the appliance. Replace this nut if it is stripped, cracked, or damaged, which can result in gas leaks or loose tubing fittings.

Replacement mounting screw for dishwashers and ranges. Secures panels, brackets, and internal components when original hardware is stripped, missing, or corroded.

Thermostat to oven pilot tubing carries gas from the thermostat to the pilot light. Replace if damaged, cracked, or leaking gas. Confirm fit with your model.

Replace your range's 3/16-inch burner sleeve if cracked, worn, or missing. This protective sleeve installs around the burner assembly on compatible models.

Secures panels, brackets, and internal components in your range. Replace stripped, missing, or damaged screws to keep parts properly aligned and secured.