Maytag Freezer Parts

Rubber grommet for refrigerators and freezers. Protects wires and components from sharp edges. Replace if cracked, worn, or missing for proper fit.

Fix a refrigerator that won't cool or run with this compressor overload protector. Prevents compressor damage from electrical overheating. Easy install.

Refrigerator not cooling or running constantly? The compressor circulates refrigerant to maintain temperature. This repair requires refrigerant handling.

Mounting screw for freezer and refrigerator installations. Replaces lost, stripped, or damaged screws. Secures internal components and panels.

Directs melted defrost water from the evaporator into the drain channel. Replace if cracked, broken, or missing to prevent water pooling in the freezer.

Seals the evaporator cover to prevent air leaks and frost buildup. Replace if you notice ice accumulation or warm air intrusion. Confirm fit by model.

Replace your freezer's exterior door handle when cracked, broken, or loose. Mounts to the front of the door for easy grip and access. Direct fit installation.

Replacement door hinge assembly for freezers. Mounts to the cabinet and door to provide smooth opening and closing. Needed when hinges are cracked or worn.

Fix a refrigerator that clicks but won't start or runs warm. This compressor start relay restores reliable startup. Simple DIY repair in under an hour.

Replacement pivot hinge for freezer or refrigerator doors. Restores smooth opening and proper alignment when the original hinge is cracked, worn, or broken.

Motor mounting bracket for freezers. Secures the motor assembly in place. Replace if cracked, broken, or causing motor misalignment or vibration.

This lock assembly secures the appliance door/lid and enables normal cycle starts by engaging the latch. Replaces a worn or broken lock to restore proper door closure and allow the unit to begin and complete cycles reliably. What it does

• Physically latches the door/lid so the appliance can start and run
• Provides the mechanical engagement the control checks before permitting operation
• Common symptom: door won't stay closed or latch does not engage
• Common symptom: appliance won't start, won't advance or shows a door/lock fault

• Disconnect power (and water supply for washers) before beginning any service
• Handle small parts carefully and note their orientation for reassembly
• If wiring is present, disconnect and reconnect matching connectors only; do not force

Thin shim that aligns and levels your freezer door at the hinge point. Replace when worn, damaged, or missing to eliminate rubbing and uneven gaps.

Interior support plate for freezers and refrigerators. Mounts inside the cabinet to hold shelving or components. Replace if cracked, broken, or missing.