Maytag Microwave Parts

Molded wire clip that secures wiring and harnesses to the microwave cabinet. Replace if broken, cracked, or missing to prevent wire rubbing and chafing.

Front vent grille that covers the microwave vent opening and directs airflow. Replaces cracked, broken, or missing grilles to restore appearance.

Microwave not heating but all other functions work? This magnetron thermostat protects against overheating. Easy DIY repair in under an hour.

Fix microwave overheating or won't heat issues with this thermostat temperature limiter. Regulates oven temperature and prevents overheating damage.

Fix inaccurate oven temperatures or won't heat issues with this oven cavity temperature sensor. Restores precise temperature control for reliable baking.

Microwave won't heat? A faulty capacitor often causes no heating or weak performance. This high-voltage capacitor restores full power. Moderate DIY.

If your microwave runs but won't heat, a failed magnetron capacitor may be the cause. This high-voltage component stores energy for the magnetron.

A small replacement button plug that fills a control-panel or console opening and restores a finished appearance. Keeps panels sealed and prevents debris from entering unused holes. What it does:

• Covers unused control holes or mounting openings on consoles and panels
• Helps block dust, moisture, and grime from entering appliance internals
• Restores a consistent, finished look to the control surface
• Useful when a damaged or missing plug leaves an exposed opening

• One button plug (black)

• Typically snaps into place from the front of the panel; no special tools usually required
• Ensure the cavity is clean and free of debris before installing for a secure fit
• If the plug sits near electrical components, disconnect power to the appliance before servicing
• Verify fit against the opening before final installation; slight trimming is not recommended unless specified

This replacement drive coupler connects the motor to the washer's drivetrain to restore normal agitation and spinning. Use it when the machine fails to drive or slips during cycles. What it does

• Transfers motor torque to the transmission/drive assembly so the tub can agitate and spin
• Commonly fitted when a worn or broken coupler causes no-spin or no-agitate symptoms
• Replaces a damaged or degraded plastic/rubber coupling that can crack or shear
• Helps stop slipping, unusually loud drive noises, or intermittent drive failures

• Disconnect power and water before any service; follow OEM safety precautions
• Basic hand tools are typically required; your model's service manual for disassembly steps
• Inspect the motor shaft and transmission input for damage when replacing the coupler
• If other drive components are damaged, replace them as recommended by the OEM

Replacement control panel touch pad for microwaves. Installs on the front control interface. Needed when buttons become unresponsive or worn.

Fix a microwave that won't heat or runs inconsistently. This temperature sensor monitors internal heat levels to regulate cooking performance.

Lower cabinet base for microwaves. Provides structural support and stabilizes the unit. Replace if cracked, damaged, or warped to restore level positioning.

Fixes uneven cooking or browning in convection mode. This motor circulates heated air throughout the cavity for consistent baking results.

Microwave light reflector directs bulb illumination inside cooking cavity. Replace if cracked, discolored, or missing to restore proper lighting. Confirm fit with your model number.