Parts for Ge PT970CM3CC: 04 - Microwave Enclosure Parts

The Guide Roller Assembly is an OEM part for GE microwaves. It supports the turntable as it rotates, ensuring even cooking by allowing the turntable to move smoothly and consistently. This assembly typically includes the rollers and the frame that houses them, fitting securely at the bottom of the microwave cavity.

Common causes of a bad guide roller assembly include normal wear and tear, exposure to heavy loads, or accidental impacts.

Symptoms of a bad guide roller assembly include:

• The turntable not rotating or moving unevenly
• Unusual noises, such as grinding or clicking, during operation
• The turntable being off-balance or wobbling
• Difficulty in installing or removing the turntable

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Support trim bracket for wall ovens. Secures and aligns trim panels to the oven frame. Replace if cracked, bent, or missing to restore proper trim fit.

Replacement air duct for your oven. Directs hot air through the cooking chamber. Order a new duct if yours is cracked, damaged, or missing.

This glass tray is a flat oven shelf that provides a smooth, easy-to-clean surface for baking and roasting. It restores a stable cooking surface and replaces cracked, chipped, or otherwise damaged oven glass trays. What it does:

• Supports bakeware and cookware for even heating on the oven floor or shelf area
• Replaces trays that are cracked, chipped, or shattered and may cause uneven cooking
• Provides a smooth, non-porous surface that's simple to wipe clean
• Helps prevent food drips from contacting the oven floor when used as intended

• One glass tray

• Handle carefully; glass can break and cause injury—wear cut-resistant gloves
• Allow the oven to cool completely before removing or installing the tray
• Inspect tray for chips or stress cracks before first use; do not use if damaged
• Follow the appliance manufacturer's instructions for placement and safe use

Inner brow trim piece for oven door assembly. Replaces cracked, broken, or missing trim components. Restores clean appearance to oven interior edge.

This trim I-brow restores the finished edge around the appliance opening to maintain a clean, factory look. It replaces a damaged or discolored upper trim piece so the front of the appliance appears complete and aligned. What it does:

• Covers and finishes the upper edge of the appliance opening for a seamless appearance
• Replaces cracked, bent, or faded trim that detracts from the appliance's look
• Helps keep the control/door area aligned with surrounding cabinetry or fascia
• Matches the original fit and mounting points for straightforward replacement

• One trim I-brow (BQ) piece as pictured

• Designed for front/upper trim replacement; follow the appliance service manual for exact removal steps
• Typical install requires only basic hand tools; support the trim while removing any mounting screws or clips
• Disconnect power to the appliance before starting work to avoid electric shock

This is a flat-head screw used to secure panels and components in compatible appliances. It provides a flush finish and reliable fastening for trim, interior panels, and small assemblies. What it does:

• Fastens trim, brackets, and small appliance components with a flat, countersunk head
• Provides a flush surface to prevent snagging and keep panels aligned
• Commonly used where a low-profile finish is needed for aesthetics and clearance

• One screw

• Use the matching Phillips or screwdriver bit; avoid over-tightening to prevent stripping
• Inspect mating threads and replace if damaged; use correct screw length to avoid puncturing internal components
• Disconnect power or follow appliance safety procedures before servicing

Nickel

Black. 8-18 AB HXW 3/8

Control wire harness for ovens. Connects control panel to internal components. Replace if wires are frayed, damaged, burned, or connections are loose.