Parts for Ge JTP85BW2BB: 02 - Microwave Inclosure Section Parts

Part has been redesigned and may require the help of a appliance technician.

This trim support bracket secures the oven or range trim assembly to keep the front trim and control bezel aligned and stable. It restores proper fit and reduces shifting or rattling of the trim pieces for a finished appearance. What it does:

• Holds trim and bezel panels in place to prevent gaps and misalignment
• Stabilizes the control panel and front trim during use
• Helps eliminate rattle or vibration caused by loose trim components
• Works as a replacement for worn or damaged trim mounting hardware

• One trim support bracket

• Disconnect power to the appliance before beginning any repair
• Minor disassembly of trim or bezels is usually required; keep fasteners organized
• Use basic hand tools and align bracket prior to tightening to avoid distortion

This trim assembly in black replaces damaged or worn exterior trim to restore the appliance's finished appearance and cover exposed edges. It fits over the control/door area to provide a clean, factory look. What it does:

• Covers and protects the appliance edge around the control/door area to hide fasteners and worn finishes
• Restores a uniform, finished appearance when original trim is cracked, chipped, or missing
• Helps keep out dirt and debris from seams around the control or door opening
• Reattaches loose trim that rattles or shifts during use

• Disconnect power to the appliance before servicing to avoid shock or injury
• Remove surrounding panels or screws as needed; retain fasteners for reinstallation
• Handle carefully to avoid scratching the finish; light trimming or alignment may be required for a flush fit

This factory screw secures components within your appliance, keeping panels, brackets, and other parts tight and aligned. Replacing a missing or stripped screw helps eliminate rattles and restores a solid, properly mounted assembly.

• Fastens appliance components to frames, brackets, or cooktop/oven structures
• Replaces missing, rusted, or stripped hardware
• Helps address loose or rattling panels and misaligned trim
• Restores a secure fit after service or cleaning

• Disconnect power; if gas, shut off the gas supply. Allow the appliance to cool completely
• Match the screw to its original location and length for proper fit
• Use the correct driver; start threads by hand to avoid cross-threading
• Tighten snugly without overtightening to prevent stripping metal or plastic

This factory screw secures components on GE cooking appliances. Replacing a lost or stripped fastener helps keep parts tight and aligned for safer, rattle-free operation.

• Fastens brackets, panels, trim, or burner components on a range, cooktop, or wall oven
• Replaces missing, corroded, or stripped hardware
• Helps reduce looseness, vibration, or rattling noises
• Restores proper alignment after service or cleaning

• Disconnect power and shut off gas supply. Allow the appliance to cool completely.
• Match this screw to the original and install in the same location.
• Use the correct driver; hand-tighten and avoid overtightening to prevent stripped threads or cracked parts.
• If mating threads are damaged, repair or replace the affected component before reassembly.

Black. 8-18 AB HXW 3/8

Nickel