Parts for Ge JTP85WW2WW: 02 - Microwave Inclosure Section Parts

Part has been redesigned and may require the help of a appliance technician.

This trim support bracket secures the oven or range trim assembly to keep the front trim and control bezel aligned and stable. It restores proper fit and reduces shifting or rattling of the trim pieces for a finished appearance. What it does:

• Holds trim and bezel panels in place to prevent gaps and misalignment
• Stabilizes the control panel and front trim during use
• Helps eliminate rattle or vibration caused by loose trim components
• Works as a replacement for worn or damaged trim mounting hardware

• One trim support bracket

• Disconnect power to the appliance before beginning any repair
• Minor disassembly of trim or bezels is usually required; keep fasteners organized
• Use basic hand tools and align bracket prior to tightening to avoid distortion

This white trim screw secures panels and plastic trim on the appliance, restoring proper fit and stopping rattles or loose pieces. It's a direct-replacement fastener used where the factory-installed screw has stripped, corroded, or gone missing. What it does

• Fastens trim, panels, or components to maintain proper alignment and fit
• Prevents vibration noise and rattling caused by loose parts
• Replaces stripped, rusted, or lost screws for a clean, finished appearance
• Matches factory finish to remain discreet in visible areas

• Disconnect power to the appliance before starting any repair
• Use the correct-size screwdriver/drill bit to avoid stripping the head
• Tighten securely but do not overtighten; excessive force can crack plastic or strip threads
• Replace only with the same part number to ensure proper fit and finish

This factory screw secures components within your appliance, keeping panels, brackets, and other parts tight and aligned. Replacing a missing or stripped screw helps eliminate rattles and restores a solid, properly mounted assembly.

• Fastens appliance components to frames, brackets, or cooktop/oven structures
• Replaces missing, rusted, or stripped hardware
• Helps address loose or rattling panels and misaligned trim
• Restores a secure fit after service or cleaning

• Disconnect power; if gas, shut off the gas supply. Allow the appliance to cool completely
• Match the screw to its original location and length for proper fit
• Use the correct driver; start threads by hand to avoid cross-threading
• Tighten snugly without overtightening to prevent stripping metal or plastic

This is a flat-head screw used to secure panels and components in compatible appliances. It provides a flush finish and reliable fastening for trim, interior panels, and small assemblies. What it does:

• Fastens trim, brackets, and small appliance components with a flat, countersunk head
• Provides a flush surface to prevent snagging and keep panels aligned
• Commonly used where a low-profile finish is needed for aesthetics and clearance

• One screw

• Use the matching Phillips or screwdriver bit; avoid over-tightening to prevent stripping
• Inspect mating threads and replace if damaged; use correct screw length to avoid puncturing internal components
• Disconnect power or follow appliance safety procedures before servicing

This factory screw secures components on GE cooking appliances. Replacing a lost or stripped fastener helps keep parts tight and aligned for safer, rattle-free operation.

• Fastens brackets, panels, trim, or burner components on a range, cooktop, or wall oven
• Replaces missing, corroded, or stripped hardware
• Helps reduce looseness, vibration, or rattling noises
• Restores proper alignment after service or cleaning

• Disconnect power and shut off gas supply. Allow the appliance to cool completely.
• Match this screw to the original and install in the same location.
• Use the correct driver; hand-tighten and avoid overtightening to prevent stripped threads or cracked parts.
• If mating threads are damaged, repair or replace the affected component before reassembly.

Black. 8-18 AB HXW 3/8

Nickel