Mixer Accessories

Flex Edge Beater is used with 3.5 Quart KitchenAid Tilt Head Stand Mixers. The Flex Edge Beater is designed to reduce mixing time when mixing with this beater. The beater features a flexible edge that thoroughly scrapes ingredients from the sides of the bowl and fits KitchenAid Stand Mixer models KSM3311 and KSM3316.

This Coated C-Dough Hook mixes and kneads yeast dough with ease, saving you both the time and effort of hand kneading. The dough hook is top-rack dishwasher safe. Fits models KSM3306, KSM3311, KSM3316, KSM3317, 5KSM3310, 5KSM3311, 7KSM3311, 9KSM3311.

This pusher assembly is the replacement actuator piece that engages and moves internal components to help normal operation. It restores proper mechanical movement and responsiveness where the original pusher is worn or broken. What it does:

• Transfers linear motion from the linkage or cam to the mating component to enable normal part movement
• Replaces damaged, cracked or worn pushers that can cause intermittent operation or failure to engage
• Helps eliminate sticking, slipping, or incomplete actuation related to a failed pusher
• Works as a direct-fit mechanical actuator when the original pusher no longer functions

• One pusher assembly (single piece)

• Disconnect power to the appliance before beginning any repair to avoid shock or injury
• Inspect surrounding parts and linkage for wear; replace any damaged components to prevent repeat failure
• Install in the same orientation as the original; secure any retaining clips or fasteners per factory alignment

This extension wand provides a rigid reach extension for compatible vacuum hoses, restoring reach and control for cleaning high or hard-to-reach areas. It replaces damaged or cracked wands to help you clean effectively. What it does:

• Extends the vacuum hose to reach ceilings, under furniture, and tight spaces
• Replaces worn, cracked, or broken wand sections that cause leaks or loss of control
• Helps maintain proper airflow by restoring a solid, sealed wand connection
• Works with existing hose and accessory fittings to resume normal vacuum operation

• One extension wand

• Disconnect the vacuum from power before removing or installing the wand
• Slide or twist the wand into the hose and accessory fittings until it locks or seats fully
• Check connection seals and replace worn gaskets or cuffs as needed for proper suction