Parts for Kitchenaid 5KCG0702BCA0: 04 - Motor And Control Parts

This is a small copper bushing used inside a garbage disposal unit. It provides a low-friction bearing surface that supports and stabilizes a rotating shaft or component. Replace this bushing if you notice excessive wobbling, grinding noises, or if the motor shaft shows signs of wear due to a worn-out bearing surface.

Fix a coffee grinder that won't start or makes grinding noise with a failed bearing. This motor restores full grinding function. Moderate DIY repair.

This small protective cap covers and shields a connection or fitting to keep out dirt, moisture and debris. It helps maintain part integrity and reduces the chance of contamination or wear to the exposed area. What it does:

• Protects a terminal, inlet/outlet or fitting from dust and moisture
• Keeps debris out of a connection to help maintain proper function
• Helps prevent corrosion or unwanted wear on exposed components
• Can be replaced when missing, cracked or damaged to restore protection

• One cap

• Disconnect power and turn off water before handling nearby components
• Remove any damaged material from the mounting area, then press or snap the cap into place until secure
• Inspect surrounding seals and fittings while replacing the cap

This cap is a small protective cover that helps keep internal components free from dust, moisture, and damage. It restores a finished appearance and shields sensitive parts from everyday wear. What it does:

• Covers and protects exposed fasteners, terminals, or openings
• Helps prevent dirt, lint, and moisture from reaching internal components
• Restores the appliance's finished look after part service or replacement
• Useful if the original cap is cracked, missing, or worn

• One replacement cap

• Disconnect power (and water, if applicable) before servicing the appliance
• Remove surrounding trim or fasteners as needed to access the mounting location
• Press or snap the cap into place; avoid forcing or prying to prevent breakage
• Ensure connections are properly seated before replacing

This is a replacement screw used to secure appliance panels and components. It restores lost or damaged fasteners so panels and trim sit tight and appliances operate without loose parts or rattling. What it does

• Replaces a lost or stripped screw that secures panels, brackets or trim
• Helps stop rattling, vibration noise or loose panels caused by missing fasteners
• Restores proper alignment of removable panels and service access points
• Provides a direct-fit fastening solution when the original screw is damaged

• One replacement screw

• Use the correct screwdriver or driver bit to avoid stripping the head
• Do not overtighten; snug until secure to avoid damaging threads or plastic parts
• Disconnect power or water and follow appliance safety procedures before servicing

Replacement power cord for coffee grinders. Connects your grinder to the wall outlet. Order a new cord if yours is frayed, damaged, or missing.

This electronic control board is the main PCB that manages a range of appliance functions and user-interface signals, restoring reliable control when the original board fails. It replaces a faulty or unresponsive control module to return normal operation. What it does:

• Controls timed cycles, user inputs and relays between sensors and components
• Powers and communicates with the appliance display and touch/key controls
• Can cause unresponsive buttons, blank or erratic display, or failed cycle starts when faulty
• May clear certain error codes by restoring proper control communication

• Always disconnect power (unplug or shut off breaker) before beginning service
• Handle the board by the edges and avoid static discharge; wear an anti-static wrist strap if available
• Basic panel removal and connector unplugging are typically required

Coffee grinder won't turn on or runs continuously? This switch controls power and grinding cycles. Simple repair for most DIYers in under 30 minutes.