Parts for Kitchenaid 5KFP1335EOB0: 02 - Motor And Housing Unit Parts

This bearing support keeps a rotating or sliding component aligned so the assembly moves smoothly and quietly. Replacing a worn support restores stable motion, reduces friction, and helps prevent noise and premature wear.

• Provides a low-friction support point for a mating shaft/arm
• Maintains alignment to prevent wobble, rubbing, or binding
• Helps the assembly operate smoothly and quietly
• Common failure signs: squeaking or grinding noises, rough/uneven movement, or excess play

• Disconnect power; shut off the water supply
• Access the assembly and note the original orientation before removal
• Transfer any clips, spacers, or screws from the old part as required by your model
• Do not add lubricants unless specified by the manufacturer; reassemble and test

This ball bearing replaces a worn washer or dryer bearing to restore smooth rotation and reduce grinding, rumbling or wobble during spin. A straightforward replacement part for noisy or binding drums or tubs. What it does:

• Supports the rotating tub/drum to ensure smooth, even spin
• Reduces loud rumbling, grinding or scraping noises caused by worn bearings
• Helps stop excessive vibration or drum wobble during operation
• Commonly replaced when the drum binds, drags, or turns unevenly

• Disconnect power (and water supply for washers) before beginning any repair
• Replacement requires partial disassembly of the cabinet/tub; support the drum/tub to avoid damage
• Bearings are typically pressed into place and require a puller/press or appropriate driver for safe removal/installation

This Motor Shaft Adapter fits over the drive post inside the work bowl to engage your food processor's blades and discs. Replacing a worn adapter restores secure coupling and smooth, consistent accessory rotation.

• Couples the motor drive post to blade and disc hubs
• Sets correct height/spacing for accessories in the bowl
• Helps prevent slipping, wobble, or uneven rotation
• Common symptoms: attachments not spinning, rattling/wobbling, uneven processing, or visible cracks/wear on the adapter

• Unplug the appliance before servicing
• Remove the work bowl and lid; lift off the old adapter if installed
• Align flats/splines and press the new adapter fully onto the drive post—do not force
• Reinstall the bowl and accessory; verify smooth engagement before use