Mtd Gold Log Splitter Parts

Muffler assembly that connects to the exhaust tube on lawn mowers and garden equipment. Replace if cracked, rusted, or damaged to restore proper exhaust flow.

Cylinder head assembly for small engines used in snow throwers and log splitters. Replaces cracked, warped, or damaged cylinder heads that compromise engine structure and seal integrity.

Replacement flywheel for small engines. This rotating wheel component stores rotational energy. Order a new one if yours is cracked, rusted, or damaged.

Fuel cap assembly for lawn and garden equipment. Covers the fuel tank refill opening. Replace if cracked, broken, or missing to prevent debris entry.

Seals the connection between carburetor and engine to prevent air leaks. Replace if cracked, brittle, or causing rough idle. Verify fit with model number.

Crankcase cover for small engines. Protects internal components from debris and damage. Replace if cracked, broken, or missing to maintain proper engine protection.

Seals the crankcase halves to prevent oil leaks in lawn mowers, tillers, and outdoor power equipment. Replace if oil is leaking or during repairs.

Seals carburetor to insulator plate, preventing fuel leaks. Replace when worn, cracked, or torn to restore engine efficiency. Verify fit with your model.

Engine won't start or runs rough? This camshaft assembly converts rotational motion to reciprocal motion for proper engine operation. Moderate DIY repair.

This replacement part is an oil seal. This is a genuine replacement part made by MTD. This part is used to ensure that oil and other fuel cannot escape from the tank. The seal prevents it from leaking during use to ensure the engine is able to run properly. A new oil seal might be needed if the current one has been damaged. If the seal is worn down and thinner than before, it can cause leaks and oil waste. If this is the case, the seal should be replaced immediately. Oil leakage can cause other issues within the machine. Refer to the owner's manual for more information on how to replace this part. This is a genuine OEM replacement part. This part is sold individually and is sourced directly from the manufacturer.

Connects piston to connecting rod inside the engine cylinder. Replace if pin is stripped, worn, or missing to restore proper piston assembly and movement.

Seals the crankcase halves on lawn mowers and outdoor power equipment. Replace if oil leaks appear or during engine rebuilds. Verify fit by model number.

Oil fill tube assembly for small engines on mowers, tillers, and chippers. Replace if cracked, damaged, or leaking. Installs on engine block.

This is an MTD rocker arm. The rocker arm works in conjunction with the engine and head. The job of the rocker arm is to push the intake valve open, allowing fuel and air to enter the cylinder. Since the rocker arm is a part of the head gasket system, any damage can cause the engine to run extremely weak. There could also be a noticeable clicking or ticking noise originating from the engine area of the mower. A visual inspection of the rocker arm will confirm any damage. Begin the repair by removing the muffler guard. After removal, move to the valve cover and remove that guard as well. Disconnect the fuel and air lines running to the head. Remove the spark plugs in the valve section. Finally, the rocker arm can be removed using a socket wrench. Repeat these steps in reverse to install the new rocker arm.This product is sourced directly from the manufacturer as a genuine OEM part. The component is available individually, separate from the original machine. This part is compatible with MTD and Cub Cadet brand equipment.

Seals the intake valve to prevent oil leaks and maintain proper compression in small engines. Replace if you notice oil consumption or performance loss.

Intake valve seal prevents air and fuel from escaping during engine operation. Replace if you notice oil consumption or reduced performance. Verify fit with your engine model number before ordering.