Parts for Ge CGU486P2T2S1: Optional Accessories Parts

Replaces a damaged, cracked, or worn griddle top cover on your gas cooktop. Restores proper fit and appearance while helping contain heat and spills.

This pad cover is a replacement protective trim that restores the appearance and protection of a damaged or worn control panel area. It helps prevent dirt and moisture from reaching switches and pads while keeping the unit looking finished. What it does:

• Covers and protects the control-pad or switch area from spills, grease, and debris
• Restores a clean, finished look to a worn or damaged panel
• Helps reduce the chance of contamination affecting underlying switches or contacts
• Commonly replaced when the panel shows visible wear, cracks, or peeling

• One pad cover as shown

• High-level replacement — remove the old cover and snap or fasten the new cover into place
• Handle carefully to avoid scratching the finish during installation
• Disconnect power or follow appliance-specific safety steps before working near electrical components
• Use only approved replacement parts for your model

This pad cover is the replacement outer cover for a range or appliance control panel, restoring a clean appearance and protecting the underlying control pad from spills, dirt and wear. It helps keep buttons accessible and the panel looking new. What it does:

• Protects the membrane/control pad from moisture, grease and debris that can cause sticking or wear
• Restores a cracked, faded or damaged control panel surface for improved appearance and usability
• Helps prevent dirt from reaching electronic controls and buttons
• Can reduce accidental presses by providing a smooth, intact surface

• Disconnect power to the appliance before attempting repairs to avoid shock or damage
• Remove trim or bezel per your model's service instructions to access the pad cover—use gentle, non-marring tools to avoid scratching surrounding surfaces
• Some pad covers snap into place; others may use adhesive or retainers—retain any original mounting clips or screws for reinstallation
• After installation, restore power and test all buttons and functions before reassembling all trim