Parts for Ge UCC15NJCII: Optional Accessories Parts

This elbow redirects the refrigerator's water supply line, providing a sealed angle connection that helps route water to the inlet valve, ice maker or dispenser. It replaces a worn or leaking elbow to restore reliable water flow. What it does:

• Provides an angled connection between the incoming water line and the refrigerator's inlet valve or water tube
• Directs water flow to internal components like the ice maker or dispenser
• Stops leaks and drips caused by cracked, warped or loose elbows
• Helps maintain proper water delivery when routing space is tight

• One elbow

• Turn off the refrigerator and shut off the water supply before starting
• Drain pressure from the water line and gently disconnect fittings to avoid damage
• Inspect and replace any worn O-rings or seals; hand-start fittings then tighten to secure
• After installation, restore water, check for leaks, and run the dispenser/ice maker until water runs clear

If your ice maker won't fill with water or stops mid-cycle, the pressure switch may have failed. This sensor detects pressure changes to control water flow.

The Handle and End Cap Assembly is an OEM part for GE ovens. This assembly comprises the handle used to open and close the oven door, along with the end caps that secure the handle firmly in place. The handle measures 27.5 inches long

Over time, the handle and end caps can become worn or damaged due to frequent use, exposure to high temperatures, or accidental impact. Such issues can make it challenging to operate the oven door properly and safely.

Symptoms of a bad Handle and End Cap Assembly include:

• Difficulty in opening or closing the oven door
• A loose or wobbly handle
• Visible cracks or damage to the handle or end caps
• The handle detaching from the oven door

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.