Parts for Whirlpool WHD862CHC1: Optional Parts (Not Included) Parts

This kit includes the components needed to reverse the swing direction of the dryer door from one side to the other. It is useful when repositioning the dryer in a new location where the current door swing is inconvenient. The kit typically includes the door, hinge hardware, and any necessary trim pieces for a complete reversal.

Fill hose for washer dryer combo units. Delivers water from supply valve to tub. Replace if cracked, leaking, worn, or connections are damaged.

This Y-shaped hose connector joins two water inlet hoses into a single connection point for the dryer's steam system. It allows hot and cold water lines to feed into the dryer for steam-based wrinkle removal or refresh cycles. Replace this connector if you notice water leaking at the hose junction or if the steam function is not working properly due to a cracked or damaged fitting.

This is a water supply hose kit used to connect a steam-equipped dryer to a household water line. It provides the water needed for the dryer's steam refresh or wrinkle-removal cycles. Replace this hose if it is leaking, kinked, or if the fittings are corroded and no longer seal properly.

This touch-up paint bottle restores small chips and scratches on painted appliance surfaces to improve appearance and help protect against rust. Easy-to-apply formula matches common appliance finishes for quick cosmetic repairs. What it does:

• Covers small chips, nicks and surface scratches to improve appearance
• Helps protect exposed metal from moisture and surface corrosion after damage
• Provides a precise application for targeted repairs on doors, panels and trim
• Can be used on painted steel and metal appliance surfaces (test in an inconspicuous area first)

• Clean and dry the repair area; remove loose paint and corrosion before applying
• Shake bottle well and apply sparingly with included applicator or a small brush
• Allow adequate drying time between coats and follow any manufacturer cure instructions on the label
• Wear gloves and work in a well-ventilated area; keep away from open flame and out of reach of children

This hose kit replaces worn or damaged appliance hoses to restore proper water flow and prevent leaks. It's a direct-fit replacement for compatible Whirlpool systems and helps stop visible leaks and restore normal fill/drain operation. What it does

• Replaces cracked, split or leaking hoses to stop water loss and reduce risk of appliance damage
• Restores reliable water flow for filling and draining functions
• Helps eliminate poor draining, intermittent filling, or water pooling near the appliance
• Works with existing clamps and connections when installed correctly

• Disconnect power and shut off the water supply before starting any repair
• Inspect connection fittings and replace clamps if worn; ensure a snug, leak-free fit
• Route hoses without kinks and secure to avoid chafing or strain
• After installation, run a short cycle and check all connections for leaks

Color: Gray. Size: 13 oz. can. Used for coating the dryer drum interior. Acrylic appliance paint.

Dryer Vent Test Kit ensures your dryer's vent system is operating properly. Kit includes two tests depending on the location of your dryer's lint screen: One for the lint screen in the top of your dryer, and one for the lint screen in the front of your dryer. Instructions included.

Rubber washer gasket for washer fill hose connections. Replace if worn or leaking at coupler adapter. Measures 1-1/16 x 5/8 inch. Verify fit with model.

Secure brackets and hardware for stacking a dryer on top of a front-load washer. Needed when vertically installing units to save floor space.

Stable platform that sits inside your dryer drum for tumble-free drying of shoes, sweaters, and delicates. Replace if cracked, warped, or missing.