Parts for Samsung 10312A: Refrigerator Page 2 Parts

This grommet is a small rubber seal that cushions and seals appliance components to reduce vibration and protect wiring or hoses. It restores proper fit and helps prevent rubbing, noise, and abrasion at the mounting point. What it does:

• Cushions and isolates moving parts to reduce vibration and rattling noises
• Protects wiring, hoses, and panels from wear where they pass through openings
• Helps form a light seal to keep out dust and debris from sensitive areas
• Restores correct part spacing and prevents metal-to-metal contact

• Inspect the mounting hole and surrounding area; replace any damaged clips or retaining hardware
• Push the grommet into the opening until fully seated; ensure wiring/hoses are routed through the grommet properly
• Disconnect power to the appliance before accessing internal components to avoid shock or injury

This guard is a molded protective trim piece that covers and shields appliance components from impacts, helps keep panels aligned, and improves the unit's finished appearance. It prevents exposed edges and reduces the chance of snags or damage. What it does:

• Covers and protects exposed appliance edges or hardware from bumps and wear
• Helps maintain proper panel alignment and a finished look
• Reduces rattling or vibration caused by loose or missing trim
• Common symptom: cracked, broken, or missing trim that exposes components or leaves gaps

• Disconnect power to the appliance or remove batteries before servicing
• Typically secures with snap tabs or a few screws; use care to avoid breaking plastic clips
• Replace only with the matching part number for proper fit

This is the replacement front control panel overlay for restoring the oven/microwave control surface and button labels. It provides a clean, readable interface so controls are easy to see and press. What it does:

• Replaces a cracked, faded, or scratched control surface to restore appearance
• Restores legible button labels and symbols for correct operation
• Helps resolve intermittent or hard-to-press buttons caused by damaged overlay
• Protects underlying electronics from spills and surface wear

• Always disconnect power (unplug or shut off breaker) before starting repair.
• Handle carefully to avoid scratching; glass/plastic edges may be sharp.
• Installation typically requires removal of trim or mounting screws and alignment clips.

This splice connector repairs a broken or damaged wire connection to restore reliable electrical contact in your appliance. It's a small, low-profile replacement that helps prevent intermittent power or component failures caused by loose wiring. What it does:

• Joins two or more wire ends to re-establish a secure electrical connection
• Commonly used where a factory wire connection has failed, become corroded, or been cut
• Can stop intermittent operation, loss of power to components, or sparking at a damaged connection
• Suitable for low-voltage appliance wiring repairs when the original splice is compromised

• Disconnect power to the appliance before inspecting or replacing wiring to avoid shock or damage
• Use proper crimping or soldering technique and insulation (heat-shrink or approved electrical tape) per local code

This outer housing cover protects internal appliance components and helps keep wiring and mechanisms secure. It restores the cabinet's finished appearance and prevents debris from entering sensitive areas. What it does:

• Shields internal parts from dust, lint and accidental contact
• Keeps wiring and connectors enclosed to reduce snagging or wear
• Helps hold adjacent panels and components in proper alignment
• Can reduce rattles or vibration caused by a missing or damaged cover

• Disconnect power (and gas if applicable) before beginning any repair.
• Inspect mounting clips and screws; replace any damaged fasteners for a secure fit.
• Handle edges carefully to avoid scratches; align tabs before fastening.