Parts for Whirlpool TU950QPXB0: 05 - Panel And Control Parts

Control panel for trash compactors. Installs on the front face to house buttons and display. Replace if cracked, damaged, or worn from daily use.

This is a right-side metal retainer bracket used to secure the trash compactor in its built-in cabinet opening during installation. It anchors the unit firmly in place to prevent shifting or vibration during compaction cycles. Replace this bracket if it is bent, broken, or missing, which can cause the compactor to move or become unstable during operation.

This is a deodorant storage compartment that holds an air freshener cartridge inside the trash compactor to help control odors. It clips or mounts inside the compactor cabinet and keeps the freshener securely in place. Replace this housing if it is cracked, broken, or no longer holds the deodorant cartridge properly.

Replacement fastener screw for appliances. Secures panels, trim, clips, and components. Needed when original screws are stripped, missing, or damaged.

Sheet metal pan head screw secures panels, brackets, and components to appliance cabinets. Replace missing, stripped, or corroded screws to restore fit.

This rotary start-run switch controls power to the appliance motor. Turning the knob engages the motor circuit to start and keep it running, restoring reliable on/off operation when the original switch wears out.

• Controls motor power using a rotary action
• Replaces a worn or intermittent switch that causes no start, stops, or inconsistent operation
• Helps resolve issues like fan/blower not turning on, cutting out, or only running in certain positions
• Designed for correct fit and dependable switching in compatible units

• Disconnect power before servicing to prevent electrical shock
• Note wire locations or take photos before removing the old switch
• Transfer wires to the same terminals on the new switch; secure connections firmly
• Test operation before reassembling any panels or knobs

Fix a broken or loose compactor control with this rotary switch knob. Restores easy setting selection when your dial is cracked, worn, or hard to turn.

Secures the rotary control switch to your trash compactor's front panel. Replace if stripped, missing, or loose to keep the control knob stable and aligned.

Fix a compactor that won't start, stops mid-cycle, or requires holding the pedal down. This drawer tilt switch is a quick 15-second replacement.

This is a pushbutton start switch used in a trash compactor to activate the compaction cycle. It is typically mounted on the control panel and engages when pressed to signal the motor to begin operating. Replace this switch if the compactor does not start when the button is pressed, operates intermittently, or the switch feels loose or unresponsive.