Parts for Speed Queen LTZA7AWN: Panels Assy Parts

A replacement self-tapping pan-head screw sized 10 x 5/8 in for securing appliance panels, trim and small assemblies. Restores proper fastening where original screws are missing, stripped or corroded. What it does

• Cuts its own mating thread in sheet metal or plastic for secure fastening
• Commonly used to attach control panels, trim pieces and small brackets
• Helps stop rattles, loose panels and misaligned trim when original fasteners fail
• Corrosion-resistant finish resists rust in typical laundry appliance environments

• Use the correctly sized screwdriver or driver bit to avoid stripping the head
• Start in a pilot hole if material is brittle or if reinstalling into worn threads
• Do not over-torque; stop when the head seats flush to avoid cracking or stripping
• Disconnect power and follow appliance-specific safety procedures before working

This hole plug is a simple push-fit seal used to close a 1-1/8" diameter access or panel opening, keeping moisture, lint, and pests out and helping maintain appliance integrity. Fits common openings found on washers and dryer cabinets. What it does:

• Seals unused access holes in the cabinet to prevent water spray or lint intrusion
• Helps maintain proper airflow paths and prevents debris buildup
• Keeps pests and contaminants from entering the appliance interior
• Provides a neat, finished appearance where a service opening is not needed

• One hole plug (1-1/8" diameter)

• Disconnect power (and water, if applicable) before servicing the appliance
• Verify the opening is clean and the measured diameter is 1-1/8" before installing
• Push the plug into the hole until flush; some installations may benefit from a light sealant if a watertight fit is required
• If the plug is damaged or hard to seat, replace with the correct-size part to ensure a proper seal