Bosch Refrigerator B18IF900SP Parts

Removes impurities from your refrigerator's water and ice supply. Replace every 6 months for clean, fresh-tasting water. Verify fit by model number.

This is a humidity sensor designed for the freezer compartment of a refrigerator. It monitors moisture levels inside the freezer to help regulate defrost cycles and maintain proper conditions for food storage. Replace this sensor if you notice excessive frost buildup, inconsistent freezer temperatures, or if the defrost system is not cycling correctly.

Secures the water filter in your refrigerator for a snug, leak-free fit. Replace if lost during filter changes, cracked, damaged, or worn out over time.

Mounting hardware kit secures refrigerator components in place. Replaces worn, missing, or damaged fasteners that cause rattling or loose parts inside unit.

Refrigerator not cooling or compressor not starting? This start relay controls the signal that initiates the compressor. Direct replacement part.

This hinge pin secures the door hinge mechanism and allows your refrigerator or freezer door to pivot smoothly. It maintains proper door alignment and prevents the door from sagging or binding. Replace this part if your door won't close properly, sags when opened, or if you hear squeaking or grinding when opening the door.

Trim strip that provides a finished edge and protective cover at its mounting location. Replace when cracked, worn, or missing to restore proper appearance.

Electronic power module for the dishwasher. This is the main control board that manages power and timing for wash, drain, and drying functions, helping restore normal operation when the original module has failed or is intermittent.

• Regulates incoming power and switches major loads (circulation pump, drain pump, heater, inlet valve)
• Coordinates cycle logic based on door and sensor inputs
• May help when the dishwasher won't power on or start a cycle
• May help when cycles stop mid-way, don't complete, or drying performance is poor

• Disconnect electrical power at the circuit breaker before servicing
• Access is typically from behind the lower toe panel/base; remove panels as needed
• Photograph and label wiring; transfer any mounting hardware; seat connectors fully
• Use ESD protection and handle the board by its edges only

Fix a refrigerator that won't cool or runs intermittently by replacing a failed compressor starting relay. Essential for proper startup and cooling.

This strip attaches inside the freezer compartment and helps guide ice away from the ice maker during the harvesting cycle. It prevents ice cubes from sticking or piling up incorrectly as they drop into the bin. Replace it if ice is jamming in the maker, cubes are not falling cleanly into the bin, or the strip is cracked or missing.

The freezer ice maker is mounted inside the freezer compartment and automatically produces, harvests, and dispenses ice cubes. Replace if it stops making ice entirely, produces hollow or malformed cubes, or continuously runs without cycling properly.

Replace a frayed or damaged power cord that's causing no power or intermittent operation. Direct plug-in replacement restores safe electrical connection.

Decorative trim piece that finishes panel or door edges on appliances. Replace worn, cracked, or missing strips to restore a clean factory look.

Small metal pin that secures and locates internal components in your upright freezer. Replace if broken, bent, missing, or no longer holding parts aligned.

This is a small wheel designed for use in a refrigerator or freezer, typically mounted on a shelf, drawer, or rack to allow smooth sliding in and out. It helps support the weight of stored items while enabling easy access. Replace this wheel if it is cracked, broken, or no longer rolling freely, causing drawers or racks to stick or sit unevenly.