Bosch Range HBL3520UC Parts

Fix an oven that won't reach set temperature or shows inaccurate readings. This temperature sensor monitors heat levels for proper cooking performance.

Replace your worn oven door gasket to restore a tight seal, prevent heat loss, and maintain consistent baking temperatures. Confirm fit with your model number.

Fix a burned out or non-working heating element in your wall oven. This replacement element restores proper temperatures. DIY-friendly, takes about 20 minutes.

Seals the oven door to retain heat and improve efficiency. Replace if you notice heat escaping or uneven cooking. Verify fit with your model number.

This is a cooling fan assembly used in wall ovens and ranges to circulate air and prevent overheating of internal components and surrounding cabinetry. It helps dissipate heat from the oven cavity and electronics during and after cooking cycles. Replace this fan if you notice excessive heat on the outer surfaces of the oven, the fan runs noisily or intermittently, or the oven displays overheating error codes.

Uneven baking or slow heating in convection mode? A failed convection fan motor stops hot air circulation. Moderate DIY repair restores even cooking.

Replacement inner door glass panel for wall ovens. Installs between door layers to restore protection when original glass is cracked or shattered.

Factory fixing kit with mounting hardware to secure panels, brackets, or trim on your wall oven. Replaces worn, missing, or damaged fasteners for alignment.

Restore oven visibility with this complete light assembly. Replace when bulb won't light, lens is cracked, or socket is damaged. Verify fit with your model.

Replacement glass panel for wall oven doors. Restores appearance when original glass is cracked, chipped, scratched, or broken. Direct fit part.

Replace your wall oven door latch if the door won't stay closed, the oven won't start, or cycles are interrupted. Restores proper door closure and locking.

This metal mounting bracket secures internal components and panels to restore proper alignment and reduce rattling. It's a straightforward replacement part that helps keep appliance panels and assemblies firmly in place for reliable operation. What it does:

• Provides a secure attachment point for panels or internal assemblies to prevent movement and vibration
• Helps correct alignment issues that can cause rubbing, gaps, or noise
• Restores the original fit where a bent, cracked, or missing bracket caused loose parts
• Works with the appliance's existing fasteners and mounting points

• Remove power and, if applicable, disconnect the appliance from water before beginning work
• Use the factory fasteners or OEM replacement screws to secure the bracket in the original location
• Verify alignment of the attached panel or assembly before fully tightening fasteners

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

Protective cap seals exposed openings on wall ovens to prevent dirt and moisture damage. Replace if cracked, missing, or loose. Verify fit with model number.

Mounting screw for ranges and cooktops. Secures panels, brackets, and components during installation. Replace if lost, stripped, or damaged.

Decorative trim plate covers seams between control panels and door edges for a finished look. Replace when damaged or discolored. Confirm fit with model.