Bosch Range HBL3520UC Parts

Seals unused ports in your wall oven to prevent moisture and debris entry. Replace if missing, damaged, or leaking. Verify fit with your model number.

Mounting clip for wall ovens. Secures the oven unit to the cabinet opening. Replace if the clip is bent, broken, or missing to ensure proper installation.

Replacement washer for electric wall ovens. Installs between components to provide secure spacing and prevent wear. Order if original is missing, damaged, or worn.

Lower trim baffle for electric wall ovens. Installs at the bottom of the oven cavity. Replace if cracked, bent, discolored, or missing to restore appearance.

This replacement cover protects internal appliance components from debris, moisture, and incidental contact so moving and electrical parts stay shielded and the appliance operates safely. It restores the original enclosure where a broken or missing cover exposes components. What it does

• Shields exposed parts from dirt, moisture, and accidental contact.
• Helps reduce noise from loose or damaged housings when missing or cracked.
• Prevents direct contact with moving or electrical components for safer operation.
• Restores OEM appearance and protects internal assemblies from wear.

• One replacement protective cover.

• Disconnect power (unplug or switch off breaker) before starting any repair.
• Use basic hand tools; avoid forcing clips or fasteners to prevent breakage.
• Inspect surrounding seals and fasteners; replace any damaged hardware.

This is a replacement mounting screw used to secure appliance panels and components. It provides a straightforward fix for loose or rattling parts and restores proper fit and alignment. What it does:

• Fastens panels, brackets, or small components to appliance frames
• Prevents rattling or movement caused by loose hardware
• Restores proper alignment for covers and access panels
• Works wherever the original screw size and thread match

• One replacement screw

• Match screw size and thread to the original before installation
• Use the correct driver to avoid stripping the head
• Do not overtighten; snug until secure to prevent damage
• Disconnect power or follow appliance safety procedures before accessing internal components

This is a cooling fan assembly used in wall ovens and ranges to circulate air and prevent overheating of internal components and surrounding cabinetry. It helps dissipate heat from the oven cavity and electronics during and after cooking cycles. Replace this fan if you notice excessive heat on the outer surfaces of the oven, the fan runs noisily or intermittently, or the oven displays overheating error codes.

This metal mounting bracket secures internal components and panels to restore proper alignment and reduce rattling. It's a straightforward replacement part that helps keep appliance panels and assemblies firmly in place for reliable operation. What it does:

• Provides a secure attachment point for panels or internal assemblies to prevent movement and vibration
• Helps correct alignment issues that can cause rubbing, gaps, or noise
• Restores the original fit where a bent, cracked, or missing bracket caused loose parts
• Works with the appliance's existing fasteners and mounting points

• Remove power and, if applicable, disconnect the appliance from water before beginning work
• Use the factory fasteners or OEM replacement screws to secure the bracket in the original location
• Verify alignment of the attached panel or assembly before fully tightening fasteners

Replace your wall oven's broken or snapped door bracket. This mounting bracket secures the lower oven door panel and attaches door clips for proper alignment.

Secures trims and seals panels against dust and vibration. Replace when adhesive weakens or components loosen. Confirm fit with your model number.

This spacer is a small structural component that maintains proper clearance between oven parts. Replace if broken, missing, or worn to ensure correct spacing.

Wall oven not heating or displaying errors? A faulty cable harness often causes electrical failures. This internal wiring assembly typically requires 1-2 hours to replace with moderate skill.