Kenmore Air Conditioner 253.79184011 (25379184011, 253 79184011) Parts

Fix an air conditioner that won't power on or has a tripping reset button with this replacement power cord. Easy 15-minute swap restores safe operation.

This is a filter drier used in a room air conditioner's sealed refrigerant system. It removes moisture and contaminants from the refrigerant to protect the compressor and other components from damage. Replace this part if the unit is not cooling properly, the refrigerant system has been opened for service, or there are signs of restricted refrigerant flow such as frost buildup on the lines.

Air conditioner not cooling or fan not spinning? This motor replacement restores airflow and cooling performance. Moderate DIY repair in 1-2 hours.

This is a thermistor-style temperature sensor that monitors the evaporator coil temperature in a room air conditioner. It sends temperature readings to the control board so the unit can regulate cooling cycles and prevent the evaporator from freezing over. Replace this sensor if the air conditioner runs continuously without cycling off, fails to cool properly, displays an error code, or if the evaporator coil ices up excessively.

A replacement dryer heater assembly that supplies the hot air needed to dry clothes. Restores normal drying performance when the original heater element fails or stops producing heat. What it does

• Heats air passing through the dryer drum so laundry dries efficiently.
• Commonly replaces a failed or open heating element causing no heat or long drying times.
• Works with the dryer's blower and thermostats to maintain operating temperature.
• Helps resolve symptoms like clothes remaining damp or extended cycle times.

• One heater assembly as shown.

• Disconnect power to the dryer before servicing to avoid shock or injury.
• Access typically requires removing the dryer rear or front panel; follow the model's service manual.
• Inspect related parts when replacing the heater.

Fix an air conditioner that won't shut off or cycles incorrectly. This sensor helps regulate temperature control. Moderate DIY repair for most users.

This capacitor helps start and run the refrigerator's compressor and/or fan motors so the appliance cools reliably. Replaces a worn or failed capacitor to restore normal motor operation and reduce hard-starting. What it does:

• Provides the initial electrical boost motors need to start turning
• Helps maintain steady motor speed during operation
• Commonly linked to symptoms like compressors that hum but don't start
• Needed if refrigerator cycles frequently or cooling is inconsistent

• One capacitor

• Disconnect power before accessing electrical components
• Discharge the capacitor before touching terminals to avoid shock
• Verify wiring and terminal orientation before reconnecting

Mounting bracket for room air conditioners. Secures and supports the unit in the window frame. Replace if bent, rusted, cracked, or missing hardware.

Seal kit for air conditioners prevents air leaks and improves cooling efficiency. Replace when seals become worn, cracked, or damaged. Verify fit with model.

Mounting bracket for air conditioner units. Secures and supports the AC chassis during installation. Replace if bent, rusted, or damaged.

Replacement retainer for room air conditioners. Secures internal components in place. Order a new retainer if yours is cracked, broken, or missing.

If your air conditioner isn't cooling evenly or has excessive frost buildup, this evaporator fan blade restores proper airflow across the cooling coils.

Air filter for room air conditioners. Replace every 30-90 days or when visibly dirty to maintain cooling efficiency and air quality. Verify fit with your model number before ordering.