Kenmore Ice Maker 3638390 Parts
Genuine Ge part
By: Ge
Part Number: WR30X10093
The Electromechanical Icemaker Kit is an OEM replacement part for GE refrigerators. It includes the ice maker assembly components responsible for harvesting, ejecting, and monitoring the ice-making process.
Symptoms of a faulty electromechanical kit include:
- Ice not being produced or dispensing properly
- The ice maker failing to turn on or stop automatically
- Strange noises emanating from the ice maker
Causes can be worn parts like the ejector assembly or drive motor, as well as electrical malfunctions. Continued use puts wear on components that regulate ice production.
This OEM GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models. Replace yours today for reliable ice on demand.
This part fixes the following symptoms
-
Ice maker not making ice
-
Ice maker won't dispense ice
-
Leaking
See more...
Do-It-Yourself Stories from Customers like You
No ice and leaking water Jeff P. • Pinecrest , FL • November 01, 2019
Much easier than expected, I was certain it had to be a water line but the solved everything
Read more
More
$182.78
- Compare At:
-
$215.68
- You Save:
-
$32.90
Genuine Ge part
By: Ge
Part Number: WR57X10033
The Water Inlet Valve is an OEM part for GE refrigerators. It is responsible for controlling the flow of water into the refrigerator’s ice maker and water dispenser. The valve opens and closes to allow the right amount of water to fill the ice maker tray or to dispense water from the refrigerator door.
Over time, the water inlet valve can wear out or become damaged due to mineral deposits, corrosion, or electrical issues. A faulty valve can lead to problems with the water supply, affecting the refrigerator’s ability to produce ice or dispense water properly.
Symptoms of a bad water inlet valve include:
- No water or ice production
- Water dispenser not working
- Leaks or drips around the valve or inside the refrigeratorStrange noises coming from the valve area
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
This part fixes the following symptoms
-
Leaking
-
Ice maker not making ice
-
Ice maker won't dispense ice
See more...
Do-It-Yourself Stories from Customers like You
The icemaker water inlet valve wouldn't close properly so water was constantly leaking into the refrigerator Ronald W. • Sagaponack , NY • September 10, 2016
I replaced the water inlet valve. The toughest part was closing off the feed line while I waited for the valve to be delivered. The needle valve used to install the feed line wouldn't close completely. I ended up fabricating a plug from some parts from the hardware store.
The mounting bracket on the new valve was completely different from the original, but it still mounted easily enough. The 1/4" plastic hose fitting was a different type from the original, but the hose fitted into it easily...
Read more
More
$39.29
- Compare At:
-
$59.14
- You Save:
-
$19.85
Genuine Ge part
By: Ge
Part Number: WR30X10154
The Ice Bucket is an OEM replacement part for GE refrigerator-freezers. It collects and stores freshly produced ice within the freezer compartment. This bucket is made of white plastic and is approximately 13 inches in length and 9 inches wide at the widest point.
Causes of a bad ice bucket can include wear and tear over time, or damage to the bucket or its components due to mishandling or impact. Please note, this is just the ice bucket and does not include the auger or auger motor.
Symptoms of a bad ice bucket include:
- Cracks or breakage in the bucket
- Ice not dispensing properly
- Bucket not fitting securely in its compartment
- Visible damage or wear to the bucket
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Used refrigerator came without ice catch bucket Arthur S. • Loiusville , KY • September 16, 2016
I ordered the bucket and it was on my door step the next afternoon,
Read more
More
$19.95
- Compare At:
-
$23.74
- You Save:
-
$3.79
Genuine Ge part
By: Ge
Part Number: WR17X1948
This refrigerator water line is the plastic tubing that routes pressurized water through the appliance's water system. Replacing a cracked, brittle, or kinked line helps restore proper water flow and prevents leaks inside or around the unit.
- Carries water between the inlet valve and the refrigerator's water system components
- Helps maintain a sealed path for reliable flow to the dispenser and/or ice maker
- Replace if tubing is cracked, kinked, brittle, or leaking
- Common symptoms include puddling, dripping, reduced/No water at the dispenser, or ice maker not filling
What's included: One water line/tube. Install notes:
- Disconnect power and shut off the water supply before servicing
- Note the original routing and clip locations; avoid sharp bends and kinks during installation
- Fully seat tubing into existing connectors/fittings on your model
- Turn water back on, check all connections for leaks, and purge air by dispensing water
Do-It-Yourself Stories from Customers like You
Old plastic water line broke and i broke the valve trying to pull the end of the water line out Ronald W. • Sagaponack , NY • May 13, 2017
I replace the water inlet valve in my refrigerator about 8 months ago. About a week ago, the old plastic water line broke. I forgot how the water line connector worked and broke the valve trying to pull it out. I got a new valve and replacement water line, and it went in easily, just like the video said.
Morals of the story:
1. Know how to remove the old plastic water line. I could have saved myself the price of a new valve if I'd remembered how the connector worked. Unless you have a really...
Read more
More
Genuine Ge part
By: Ge
Part Number: WR2X4754
This clamp secures small hoses or tubing and nearby wiring inside the appliance to keep lines held in place and reduce rubbing, leaks, or vibration noise. It's a direct-fit replacement designed to restore proper hose routing and stability. What it does:
- Holds water, drain or vent tubing securely to prevent sagging and rubbing that can cause leaks or wear
- Keeps hoses and wires aligned to reduce vibration and rattling during operation
- Helps maintain proper connections at fittings so seals stay seated and drip risk is minimized
- Simple mechanical clip action — no special tools or adhesives required
Install notes:
- Disconnect power and shut off the water supply before starting any repair
- Remove the old clamp and install this clamp in the same orientation; tubing sits fully in the fitting
- Use standard pliers (or the OEM-recommended tool) to compress/seat the clamp; avoid twisting or pinching the tubing
- Inspect surrounding tubing and fittings for wear; replace damaged hoses or seals if found
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more
More
$6.95
- Compare At:
-
$8.36
- You Save:
-
$1.41
Genuine Ge part
By: Ge
Part Number: WR57X57
Nut for 1/4 inch tubing.
Do-It-Yourself Stories from Customers like You
Frigidaire refrigerator model FRS3HR5HMB5 having issues with ice buildup around the evaporator fan have had similar issue for three to four years Keith C. • Cypress , TX • November 12, 2018
Changed the Frigidaire Icemaker Fill Tube Part # 241796405 (AP5671747) about a week ago and so far the Frigidaire Refrigerator seems to work fine. Did not use other ordered parts. Recently ice formed around internal evaporator fan and it started making loud noise when then fan and compressor, etc were running. A long winded history noted below if interested:
I have been fighting with this Frigidaire Refrigerator for about 3 to 4 years, started out with the evaporator fan making noise when ice...
Read more
More
$7.37
- Compare At:
-
$8.36
- You Save:
-
$0.99
Genuine Ge part
By: Ge
Part Number: WR1X5278
This cable clamp secures refrigerator wiring to the cabinet, keeping harnesses organized and protected. Replacing a missing or damaged clamp helps prevent chafing and vibration noise while maintaining proper clearance from fans and other moving components.
- Anchors wire harnesses in their designed routing
- Helps prevent insulation wear from rubbing or vibration
- Keeps wires clear of sharp edges and moving parts
- Common signs it's needed: missing/broken clamp, loose or dangling wires, or new rattling/buzzing noises
What's included: 1 cable clamp Install notes:
- Disconnect power before servicing
- Access the clamp location and note original wire routing
- Position the clamp and secure with the existing fastener; do not overtighten
- Ensure wires aren't pinched and have clearance from the fan/compressor before restoring power
More
$7.37
- Compare At:
-
$8.36
- You Save:
-
$0.99
Genuine Ge part
By: Ge
Part Number: WR2X4039
This small hardware clamp is used on select refrigerators to secure tubing or wiring to the cabinet or frame. Replaces a missing or damaged clamp to keep lines stable, reduce vibration, and help prevent rubbing or leaks.
- Secures small water tubing or electrical harnesses along the cabinet/frame
- Helps prevent vibration, rattling, and abrasion of lines
- Maintains correct routing to keep lines clear of moving or hot components
- Common clues: loose or noisy lines, chafing marks, or moisture near tubing connections
What's included: 1 clamp Install notes:
- Unplug the appliance and shut off the water supply before servicing
- Note the original location and routing; take a photo for reference
- Reuse the existing mounting screw/fastener if required; tighten only enough to hold without crushing tubing
- Restore power and water, then run and inspect for vibration and leaks
Do-It-Yourself Stories from Customers like You
Needed ice maker Ronald J. • Oskaloosa , KS • February 11, 2022
Bough ice maker
Read more
More
$7.37
- Compare At:
-
$8.36
- You Save:
-
$0.99
Genuine Ge part
By: Ge
Part Number: WR30X10081
This is a 220v international model icemaker.
More
$284.77
- Compare At:
-
$307.78
- You Save:
-
$23.01
Genuine Ge part
By: Ge
Part Number: SR3653
$11.95
- Compare At:
-
$12.92
- You Save:
-
$0.97
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: SR6146
This printed user manual provides the original operating instructions, safety information, and basic troubleshooting guidance for your appliance. Keep it on hand for safe operation and quick reference during regular use. What it does:
- Explains appliance controls, settings, and normal operation in plain language
- Lists important safety precautions and proper use recommendations
- Offers basic troubleshooting tips to identify common user issues
- Describes routine care and maintenance tasks to help preserve performance
What's included: One printed user manual Install / use notes:
- No tools required; store the manual nearby the appliance for easy access
- Keep the manual dry and free from grease or heavy wear to preserve readability
- If damaged or lost, consult the manufacturer's website for a digital replacement
- This item is documentation only — it does not include physical replacement parts
More
$7.39
- Compare At:
-
$8.13
- You Save:
-
$0.74
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WR29X5171
Do-It-Yourself Stories from Customers like You
Icemaker would not stop making ice Henry T. • Huntersville , NC • November 23, 2014
Determined from the schematic on the inside of the cover of the icemaker that the likely problem was the "stop" micro switch.... Took the whole thing apart and confirmed the switch was defective.
Replaced it with a standard DPDT switch - for a temporary fix. Went on line to find replacement. Bought it from APP Parts Pros. replaced DPDT switch with micro.. all is well.... saved at least $150 by not having a repair person come to the house - felling good about this.....
Read more
More
Genuine Ge part
By: Ge
Part Number: WR29X204
Genuine Ge part
By: Ge
Part Number: WR29X5168
Genuine Ge part
By: Ge
Part Number: WR29X5174
Genuine Ge part
By: Ge
Part Number: WR29X0151