Kenmore Air Conditioner 580.78122890 (58078122890, 580 78122890) Parts

Replace a missing or damaged installation kit with this Install Part Assembly. Designed for select air conditioners, it helps secure and seal the unit during setup for a stable fit and reliable performance.

• Provides the correct mounting/finishing components needed for proper installation
• Helps seal the opening to minimize air leaks and reduce vibration/noise
• Restores secure, stable support of the chassis during and after install
• Symptoms indicating replacement: incomplete installation, loose fit, rattling, or drafts around the unit

• Disconnect power before beginning; use two people to lift and support the unit
• Follow the model's installation instructions carefully
• Inspect the opening/sleeve; install level and tighten all fasteners securely
• After installation, verify a tight perimeter seal and stable, rattle-free operation

Replacement drain pipe that routes wastewater from the appliance pump to the home drain. Restores proper drainage and helps prevent leaks or standing water when the original tubing is cracked, clogged, or damaged. What it does

• Directs wastewater from the pump to the household drain so the appliance can complete normal drain cycles.
• Replaces cracked, split, kinked, clogged, or leaking tubing that can cause slow draining or standing water.
• Fits the OEM drain outlet and drain connection; secures in place with hose clamps to maintain a watertight seal.
• Matches OEM shape and routing to avoid pinches or improper drainage.

• Always unplug the appliance and turn off the water supply before beginning service.
• Remove the access panel to reach the pump/drain connections; detach the old pipe and install the replacement in the same orientation.
• Use the original hose clamps or replace with equivalent clamps; tighten until snug—avoid overtightening.
• After installation, run a short drain cycle and check all connections for leaks.

This blower is the rotating wheel that moves air through the dryer to support proper drying and venting. Replacing a worn or damaged blower restores airflow for more efficient, consistent drying performance. What it does

• Spins to pull air from the drum through the heater and out the vent
• Restores normal airflow when a blower wheel is cracked, broken, or missing fins
• Helps reduce long dry times, overheating, or unusual noises caused by a failing blower
• Works with the dryer motor and housing to maintain proper ventilation

• One blower wheel

• Disconnect power to the dryer before starting any repair
• Access typically requires removing the dryer front or rear panel and detaching the drum or blower housing
• Inspect the motor shaft and mounting hardware; replace any worn fasteners or bearings as needed

This replacement power cord assembly restores the main AC connection that supplies electricity to your appliance. It provides a direct, low-resistance path for safe operation and helps resolve power-loss symptoms. What it does:

• Replaces a damaged or frayed main power cord to restore reliable power delivery
• Helps fix intermittent power, appliances that won't turn on, or cords with visible damage
• Ensures proper ground and secure connection when original cord is worn or broken
• Matches OEM fit and routing to align with the appliance's strain relief and connector

• Disconnect the appliance from power before beginning any work.
• Follow the appliance service manual for disassembly and routing to avoid pinched wires.
• Confirm the connector orientation and secure strain relief or mounting bracket as shown in the OEM instructions.