Bosch Freezer B18IF905SP Parts

Door hinge pin for upright freezers. Installs in the door hinge assembly to support smooth door operation. Replace if pin is worn, bent, or missing.

Mounting screw for refrigerators and freezers. Secures internal components and panels. Replace if stripped, missing, or corroded during repairs.

Replacement control panel for upright freezers. Installs on the front exterior to house display and controls. Order when original is cracked, damaged, or missing.

This is the dishwasher sump filter housing that secures the filter assembly and helps trap food debris so wash water drains and circulates properly. Replaces a worn or cracked housing to restore proper filtration and flow. What it does:

• Houses the coarse/fine filter assembly and keeps filter components aligned
• Directs wash and drain water through the filter area to protect the pump
• Helps prevent large food particles from entering the pump and spray system
• Commonly used when filters are loose, cracked, or when debris is bypassing the filter

• Disconnect power and water supply before starting any repair
• Remove lower dishwasher rack and existing filter assembly to access the housing
• Inspect mating seals and gaskets; replace if brittle or damaged
• Reassemble filter components per OEM diagram and run a short cycle to check for leaks and proper drainage

Wire freezer basket organizes frozen foods in the freezer compartment. Replace if cracked, broken, bent, or missing to restore storage space.

This condenser coil assembly removes heat from the refrigerant so your refrigerator can maintain proper cooling. Replaces a worn or damaged condenser to help restore normal compressor cycling and heat dissipation. What it does

• Dissipates heat from refrigerant after compression to support the cooling cycle.
• Helps maintain proper compressor operation and efficient cooling performance.
• A damaged or clogged condenser can cause longer run times, higher energy use, or reduced cooling.
• Restoring a functioning condenser can reduce compressor stress and temperature-related issues.

• One condenser coil assembly.

• Disconnect power to the appliance before starting any repair.
• Replacing this condenser may require access to sealed refrigerant lines; use a certified HVAC technician.
• Handle carefully to avoid bending fins or damaging tubing; wear gloves to protect against sharp edges.
• Verify all connections are secure and check for leaks or unusual noises after reassembly.

This right-side hinge cover restores a clean, finished look to the appliance door while protecting the hinge area from dirt and accidental contact. Durable plastic construction replaces cracked, broken, or missing covers. What it does:

• Protects the door hinge and surrounding area from dust, debris, and accidental bumps
• Conceals hinge hardware for a finished appearance
• Helps prevent accidental contact with moving hinge parts
• Commonly replaced when cracked, warped, or missing after impacts or wear

• Disconnect power to the appliance before beginning repairs when working near electrical components
• Remove the door or open as needed to access the hinge
• Use appropriate hand tools and avoid forcing clips or tabs to prevent breakage
• If hinge hardware is damaged or door alignment issues persist, inspect hinge components and follow the OEM service instructions

Exterior trim piece that covers and protects the door hinge area. Replace when original is cracked, scratched, missing, or worn to restore appearance.