Bosch Refrigerator B36CD50SNB Parts

This exhaust baffle directs and protects the dishwasher vent to help prevent steam and food debris from entering the vent path. It restores proper venting to reduce steam buildup and help maintain drying performance. What it does:

• Guides exhaust steam out of the dishwasher and away from the cabinet
• Helps block food particles and debris from entering the vent path
• Reduces visible steam and condensation around the door area
• Supports consistent draining of moisture from the tub during the drying cycle

• One exhaust baffle

• Designed to replace a damaged or missing vent baffle; verify fit with your model before installing
• Typically snaps or slides into place—no special tools required for many models
• Disconnect power and water to the appliance before performing any repairs

This cable harness routes power and signals between the dishwasher control board and internal components so the appliance can communicate and operate correctly. It replaces a damaged or worn wiring loom to restore reliable connections. What it does

• Carries power and low-voltage signals from the control board to motors, valves, sensors and other components
• Re-establishes broken or intermittent electrical connections that can cause faults or non-start conditions
• Helps eliminate erratic behavior caused by frayed wires, loose terminals or corroded connectors
• Supports accurate sensor readings and control responses when connectors are secure

• Disconnect power to the appliance before beginning work to avoid shock or injury
• Note connector locations and wire routing before removing the old harness; take photos if helpful
• Re-seat each connector fully and secure the harness to the chassis to prevent chafing or pinching
• If you see burned or melted connectors, inspect surrounding components and replace as needed

This replacement cover is a simple exterior access panel that protects internal components and restores a finished appearance. It keeps wiring and mechanisms shielded while keeping the appliance looking complete. What it does:

• Shields internal components from dirt, dust and accidental contact
• Helps reduce noise by covering openings where parts are mounted
• Restores the appliance's finished look if the original cover was cracked or missing
• Can prevent small objects from falling into service areas and causing damage

• Disconnect power to the appliance before beginning any work
• Remove fasteners or clips securing the old cover; keep screws for reuse if applicable
• Align cover carefully to avoid pinching wiring or misplacing mounting tabs