Bosch Refrigerator B36CT80SNB Parts

Replacement slide rail for bottom-mount refrigerator drawers. Installs along the drawer track to support smooth gliding. Order when original rail is cracked or broken.

Interior shelf fixture for bottom-mount refrigerators. Replaces cracked, broken, or missing shelf support fixtures. Installs inside the fresh food compartment.

Replace your dim or flickering refrigerator fluorescent light bulb to restore bright interior visibility. Direct fit for bottom-mount models. Easy DIY swap.

Fix rattling or loose components in your refrigerator with this retaining plate. Secures internal parts to reduce noise and prevent wear. Easy to install.

Fix ice buildup in your bottom-mount refrigerator with this defrost heater assembly. Restores proper defrost cycle when frost accumulates on evaporator coils.

This door switch is the electromechanical switch that tells the appliance when the door is closed so it can start and run. It restores proper door sensing for safe operation and normal cycle starts. What it does:

• Detects when the door is fully closed and completes the circuit to allow the appliance to start.
• Prevents the motor or heating elements from running if the door is open.
• Commonly linked to symptoms such as the unit not starting, stopping mid-cycle, or display/controls not responding to door closure.
• Acts as the interface between the door latch/handle and the appliance's control system.

• One door switch assembly.

• Disconnect power (and water, if applicable) before starting any repair.
• Access may require removing the control panel, door trim, or kick plate—follow OEM service instructions.
• Handle the switch and connector gently to avoid damaging terminals or wiring harnesses.

Control panel buttons not visible or dim? This light bar illuminates your refrigerator's control panel so you can see settings and indicators clearly again.

Fix water dispenser leaks or no water flow with a new water valve. This part controls water pressure to your refrigerator dispenser and ice maker.

This is a guide rail that supports and directs a refrigerator drawer as it slides in and out. It mounts inside the refrigerator cabinet and ensures smooth, straight movement of the drawer. Replace this guide if the drawer is sticking, tilting, falling off track, or no longer sliding properly.

Guides the lower dish rack smoothly along its track. Replace if cracked, broken, or worn to restore proper alignment and prevent rack derailment.

This power module is the electronic control that supplies and manages power to appliance components, restoring proper control functions and operation when the original module has failed. It offers a direct replacement for the failed control electronics. What it does:

• Regulates and distributes electrical power to the appliance's control circuits and motors
• Replaces a failed or intermittent power/control source that can cause no-power or erratic operation
• Commonly used when the unit will not start, resets unexpectedly, or displays control errors
• Helps restore normal operation when diagnostics identify the module as the faulty component

• Disconnect all power before accessing or replacing the module to avoid shock or damage
• Handle the module by its edges and avoid contact with electronic components or terminals
• Secure mounting and connector seating are required

This is a two-way symmetrical air damper that controls the flow of cold air between compartments in the refrigerator. It regulates temperature by opening and closing to direct airflow as needed. Replace this damper if one compartment is too warm or too cold, if you hear unusual clicking near the vent area, or if the damper is visibly stuck in the open or closed position.

The Suspension is an OEM part specifically designed for Bosch refrigerators. It anchors the refrigerator cabinet to reduce vibrations and ensure stable positioning during compressor operation. 

Symptoms of a bad suspension include: 

• Excessive shaking or rattling noises from within the cabinet 
• Physical movement of the refrigerator away from the wall  
• Loose fixture mounting points developing cracks or breaks

Causes of a bad suspension can be degradation over extended usage periods, damage from service repairs disrupting mount alignment, or failure after impact loads to cabinet corners.

Replacing with this OEM suspension restores proper shock absorption to maintain consistent temperatures. Its robust design supports appliance longevity in any kitchen environment.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models. Replace to avoid future service hazards from unsecured cabinets.
 

Replacement shelf rail for bottom-mount refrigerators. Replace if shelves stick, won't slide, or rail is cracked. Verify fit using your model number.

The adjusting screw allows you to level your refrigerator and adjust door alignment, typically located at the base of the unit. Replace when the screw becomes stripped, corroded, or can no longer properly support or adjust the refrigerator.

This replacement drawer restores the dishwasher's cutlery/utensil storage and smooth slide action so you can load small items securely and maintain cleaning performance. Designed as a direct replacement drawer assembly. What it does:

• Provides a dedicated tray for silverware and small items to improve loading flexibility.
• Slides in and out smoothly to allow easy loading and unloading.
• Replaces cracked, warped, or broken drawers that no longer hold utensils securely.
• Helps prevent rattling or poor wash coverage caused by damaged or misshapen drawers.

• Turn off power to the appliance before beginning any service.
• Remove upper racks as needed for access; follow your model-specific service instructions.
• Handle edges carefully to avoid damage to the drawer or surrounding trim.
• If clips, rails, or mounting hardware appear damaged, inspect and replace those components per the manufacturer's instructions.