Bosch Refrigerator B36CT80SNB Parts

This cable harness routes power and signals between the dishwasher control board and internal components so the appliance can communicate and operate correctly. It replaces a damaged or worn wiring loom to restore reliable connections. What it does

• Carries power and low-voltage signals from the control board to motors, valves, sensors and other components
• Re-establishes broken or intermittent electrical connections that can cause faults or non-start conditions
• Helps eliminate erratic behavior caused by frayed wires, loose terminals or corroded connectors
• Supports accurate sensor readings and control responses when connectors are secure

• Disconnect power to the appliance before beginning work to avoid shock or injury
• Note connector locations and wire routing before removing the old harness; take photos if helpful
• Re-seat each connector fully and secure the harness to the chassis to prevent chafing or pinching
• If you see burned or melted connectors, inspect surrounding components and replace as needed

This replacement cover is a simple exterior access panel that protects internal components and restores a finished appearance. It keeps wiring and mechanisms shielded while keeping the appliance looking complete. What it does:

• Shields internal components from dirt, dust and accidental contact
• Helps reduce noise by covering openings where parts are mounted
• Restores the appliance's finished look if the original cover was cracked or missing
• Can prevent small objects from falling into service areas and causing damage

• Disconnect power to the appliance before beginning any work
• Remove fasteners or clips securing the old cover; keep screws for reuse if applicable
• Align cover carefully to avoid pinching wiring or misplacing mounting tabs