Bosch Refrigerator B36ET71SN Parts

Replaces broken or missing access cap cover on your refrigerator. Shields internal components from dirt and moisture while maintaining clean appearance.

This is an electrical on/off switch used to control power to an appliance circuit. It replaces a failed switch so controls respond normally and the appliance can be powered on and off safely. What it does

• Opens and closes an electrical circuit to enable or disable appliance power or a specific control function
• Commonly replaces a worn, stuck, or unresponsive switch that prevents controls or lights from operating
• Can resolve symptoms like no power to a control, intermittent operation, or a button that won't actuate
• Designed to mate with the appliance's existing wiring and mounting points

• One electrical on/off switch

• Disconnect power to the appliance at the breaker or unplug before working on wiring
• Verify proper wire locations and secure all terminal connections; replace only with the exact part specified by the manufacturer
• Handle the part carefully to avoid bending terminals or damaging the switch actuator

Decorative trim strip that covers the edge of your refrigerator door panel. Replaces cracked, missing, or worn trim to restore a clean, finished look.

Lower front kick plate that covers the bottom of your refrigerator. Replace if your original panel is cracked, bent, damaged, or missing for a finished look.

Replacement door support bracket for your refrigerator. Installs on the door hinge area to provide structural support. Order now if cracked or broken.

Mounting screw for bottom-mount and upright refrigerators and freezers. Secures internal components and panels. Replace if stripped, missing, or damaged.

This is a mounting bracket or fixture used inside the refrigerator or freezer compartment. It serves as a support structure for securing internal components in place. Replace this bracket if it is cracked, broken, or no longer holds the associated component securely, causing misalignment or rattling.

Protective housing cover shields internal refrigerator components from debris and moisture. Replace if cracked, broken, or missing to maintain safe operation.

Replacement cover panel for refrigerator interior components. Installs to conceal wiring or mechanisms. Order new cover if original is cracked or missing.

Light fixture for bottom-mount refrigerators. Installs in the interior compartment to house the bulb. Replace if cracked, broken, or damaged. Direct fit.

Decorative stripe trim for refrigerator doors. Installs along the door edge to provide a finished appearance. Replace if cracked, peeling, or missing.

Replacement drawer for your refrigerator. Installs in the fresh food or freezer compartment. Needed when original drawer is cracked, broken, or missing.

This is a left-side mounting bracket located inside the freezer compartment of your refrigerator. It provides structural support for interior components such as shelves, light fixtures, or covers. Replace this bracket if it is cracked, broken, or if the component it supports is loose or misaligned.

This insulating part provides thermal and electrical isolation between adjacent components to protect wiring and assemblies. It helps prevent heat transfer and electrical contact for safer, more reliable appliance operation. What it does:

• Separates metal parts and wiring to reduce risk of shorting or contact-related wear
• Helps limit heat transfer between hot components and sensitive parts
• Cushions and stabilizes small assemblies to reduce vibration-related damage
• Commonly replaced when the original insulator is cracked, melted, or missing

• One insulating part

• Always disconnect power to the appliance before starting any repair
• Verify correct orientation and seating; do not deform or pinch the insulator during installation
• Replace any damaged fasteners or clips and ensure wiring is routed away from heat sources

This is a metal slide rail that guides a freezer drawer in and out of the cabinet smoothly. It mounts on the interior side wall of the freezer compartment and supports the drawer's weight during operation. Replace this rail if the drawer feels sticky, uneven, or won't slide properly, or if the existing rail is bent or broken.