Bosch Refrigerator B36IT800NP Parts

Restores proper door alignment and smooth operation. Replace if your refrigerator door sags, drags, or has uneven gaps. Verify fit with your model number.

This is a strip that helps release ice from the ice maker mold so cubes can drop into the storage bin. It acts as a guide or ejector aid during the ice harvesting cycle. Replace this part if ice cubes are not ejecting properly, getting stuck in the mold, or if the ice maker produces misshapen or clumped ice.

Secures panels, trim, and internal components in your refrigerator. Replace if the original clip is cracked, broken, or missing to restore proper fit.

This control transformer steps down incoming household voltage to the lower voltage needed by the appliance's control electronics, allowing the control board and user interface to operate safely and reliably. What it does:

• Supplies a stable low-voltage source for the control board and user interface circuits
• Helps restore power to controls when a failed transformer causes unresponsive buttons or blank displays
• Prevents overvoltage from reaching sensitive electronics when functioning correctly
• Common symptom of failure: controls not powering up or intermittent control operation

• One replacement transformer as shown

• Always disconnect power at the breaker or unplug the appliance before servicing
• Handle wiring and connectors carefully; match wire colors and terminal positions during reinstallation
• Inspect mounting hardware and replace any damaged clips or screws for secure installation

Decorative trim strip for bottom-mount refrigerators. Installs along cabinet edges to cover gaps and provide a finished look. Replace if cracked or missing.

Condensate water container collects moisture from your refrigerator's cooling system. Replace if cracked, broken, or leaking to prevent water damage.

Protective housing cover for refrigerator internal components. Shields parts from debris and moisture. Replace when cracked, broken, or missing.

Replace a cracked or missing housing cover that exposes internal components to debris and moisture. Restores proper sealing and component protection.

This is an electrical on/off switch used to control power to an appliance circuit. It replaces a failed switch so controls respond normally and the appliance can be powered on and off safely. What it does

• Opens and closes an electrical circuit to enable or disable appliance power or a specific control function
• Commonly replaces a worn, stuck, or unresponsive switch that prevents controls or lights from operating
• Can resolve symptoms like no power to a control, intermittent operation, or a button that won't actuate
• Designed to mate with the appliance's existing wiring and mounting points

• One electrical on/off switch

• Disconnect power to the appliance at the breaker or unplug before working on wiring
• Verify proper wire locations and secure all terminal connections; replace only with the exact part specified by the manufacturer
• Handle the part carefully to avoid bending terminals or damaging the switch actuator

Mounting fixture that secures internal refrigerator components. Replace when original hardware is worn, damaged, or missing to restore proper alignment.

Replace your refrigerator's compartment lid cover if cracked, broken, or missing. This lid installs in the fresh food section to cover storage bins.

Lower trim panel that covers the kick area at the bottom of your refrigerator. Replace if cracked, dented, or missing to restore a finished look.

Fixes incorrect temperature readings or frequent cycling. This thermistor monitors compartment temp for proper cooling. Moderate DIY repair, 30-45 minutes.