Bosch Refrigerator B36IT905NP Parts

Sealing cap covers service or fluid ports to prevent leaks and contamination. Replace if cracked, loose, or missing to restore secure closure.

This is the dishwasher sump filter housing that secures the filter assembly and helps trap food debris so wash water drains and circulates properly. Replaces a worn or cracked housing to restore proper filtration and flow. What it does:

• Houses the coarse/fine filter assembly and keeps filter components aligned
• Directs wash and drain water through the filter area to protect the pump
• Helps prevent large food particles from entering the pump and spray system
• Commonly used when filters are loose, cracked, or when debris is bypassing the filter

• Disconnect power and water supply before starting any repair
• Remove lower dishwasher rack and existing filter assembly to access the housing
• Inspect mating seals and gaskets; replace if brittle or damaged
• Reassemble filter components per OEM diagram and run a short cycle to check for leaks and proper drainage

If your appliance display is blank, flickering, or showing error codes, the display module may need replacement. This repair restores control panel functionality.

Replacement rack guide rail for dishwasher racks. Installs along the side to enable smooth sliding. Replace if cracked, broken, or worn to restore proper alignment.

This fixture is a small mounting bracket used to secure internal components inside the appliance, helping keep parts aligned for reliable operation and preventing movement-related noise or wear. It's a direct-replacement style part built to restore proper fit and stability. What it does:

• Provides a secure mounting point to hold internal components in place
• Keeps assemblies aligned to reduce vibration and noise during operation
• Helps prevent rubbing or binding that can cause premature wear
• Restores correct component spacing for reliable function

• One fixture (mounting bracket)

• Disconnect power and shut off water before beginning any repair
• Access the part by removing the outer panel or relevant access cover per your model's service instructions
• Inspect surrounding clips and fasteners; replace any damaged hardware for a secure fit