Bosch Dishwasher DF480701F Parts

Replacement dishwasher seal creates a watertight connection between components. Replace when leaks or pooling occur. Verify fit with your model number.

Fix dishwasher spray arm not rotating with this spindle shaft. Restores proper water distribution when the rotating shaft is worn or broken.

This auxiliary service tool is used to perform specific installation and repair steps as defined by the manufacturer. It helps technicians safely engage, align, or remove components during approved procedures on compatible appliances. What it does:

• Provides the exact tool profile specified by the manufacturer for select service procedures
• Assists with controlled removal/installation of clips, springs, or fittings as directed in service literature
• Helps align or seat components during assembly to prevent damage
• Intended for use by trained servicers following the official procedure for your model

What's included: 1 auxiliary tool Install notes:

• Disconnect power and shut off water and/or gas before servicing
• Follow your model's official service manual for when and how to use this tool
• Wear protective gloves and eye protection; parts may have sharp edges or spring tension
• Keep hardware organized and correct operation and leak-free connections before restoring service

Trim strip finishes the exposed edge of your dishwasher where it installs. Replace if cracked, broken, or missing to restore a clean, finished look.

This is the base panel that attaches along the bottom front of the dishwasher, covering the underside components such as the motor and water connections. It helps protect internal parts from debris and provides a finished appearance. Replace this panel if it is cracked, warped, missing, or damaged from leaks or kicks.

This bearing clip secures a drum/tub bearing assembly to keep the bearing properly seated, helping maintain stable drum rotation and reduce wobble. Replace a worn or broken clip to restore correct bearing alignment. What it does:

• Holds the bearing in position so the drum/tub spins smoothly
• Prevents the bearing from shifting or slipping out of its mounting
• Can help reduce noise and wobble caused by a loose bearing
• Works as part of the bearing support system for the washer/drum assembly

• Recommended for installers or experienced DIYers; the correct service panels are removed before accessing the bearing area
• Disconnect power and water supply before beginning any repair
• Inspect adjacent bearings, seals, and mounting surfaces for wear and replace as needed
• Use proper tools to avoid damaging the clip or surrounding components during removal and installation

Flexible plastic tube that routes water between dishwasher components. Replaces cracked, split, or worn tubes that cause leaks or water pooling.

Replacement screw that secures the fascia or control panel to the dishwasher cabinet. Needed when original fastener is stripped, missing, or damaged.

Replace your dishwasher's detergent dispenser lid if it's cracked, broken, or missing. This cover snaps onto the dispenser to keep detergent secure.

Replaces broken or damaged dishwasher mounting holder that secures internal components. Restores stable alignment and reduces noise from loose parts.

Dishwasher holder component that secures parts in place during operation. Replace if cracked, broken, or missing to restore proper fit and alignment.

Dishwasher bearing supports rotating spray arms for smooth operation. Replace if you hear grinding noises or arms wobble. Confirm fit with your model.

Replacement mounting screw that secures panels and components. Needed when original fastener is lost, stripped, or damaged to keep assembly stable.