Bosch Dishwasher DF481700F Parts

The Funnel is an OEM part for Bosch dishwashers. It helps accurately guide water from the inlet valve onto wash arms and other components inside the dishwasher.

As water flows through the funnel during each cycle, small debris particles can become trapped. Over time, a buildup of mineral deposits or grime occurs inside the funnel.

Causes are normal mineral accumulation from hard water, along with food particles or grit trapped during dishwasher use.

Symptoms of a bad funnel include:

• Reduced or uneven water pressure to spray arms
• Clogs or blockages that hamper water flow
• Mineral deposits visible inside the funnel

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Lower kick plate that covers the front bottom of your dishwasher. Replace if cracked, bent, damaged, or missing to restore cabinet appearance.

Dishwasher bottom case base assembly forms the lower enclosure protecting internal components. Replace if cracked, broken, or damaged to restore stability.

Protective cover for your dishwasher. Shields internal components from moisture and debris. Replace if cracked, broken, or missing to maintain protection.

Reduces hard-water minerals to prevent spotting and buildup on dishes and glassware. Replace when dishes show mineral deposits. Verify fit by model number.

Replace your broken or cracked dishwasher detergent dispenser door lid. This cover installs on the dispenser compartment to keep detergent secure.

This auxiliary service tool is used to perform specific installation and repair steps as defined by the manufacturer. It helps technicians safely engage, align, or remove components during approved procedures on compatible appliances. What it does:

• Provides the exact tool profile specified by the manufacturer for select service procedures
• Assists with controlled removal/installation of clips, springs, or fittings as directed in service literature
• Helps align or seat components during assembly to prevent damage
• Intended for use by trained servicers following the official procedure for your model

What's included: 1 auxiliary tool Install notes:

• Disconnect power and shut off water and/or gas before servicing
• Follow your model's official service manual for when and how to use this tool
• Wear protective gloves and eye protection; parts may have sharp edges or spring tension
• Keep hardware organized and correct operation and leak-free connections before restoring service

Trim strip finishes the exposed edge of your dishwasher where it installs. Replace if cracked, broken, or missing to restore a clean, finished look.

Does your dishwasher shake or make loud noises during the wash cycle? A worn suspension damper may be the cause. This part absorbs vibration and stabilizes the tub.

Replace your dishwasher sealing gasket to restore watertight connections and prevent leaks. Install when you notice water escaping from joints or seals.

Replacement access panel cover for dishwashers. Shields internal components from dust and moisture. Needed when original is cracked, broken, or missing.

This ventilation duct is the in-line connector that channels exhaust air from the appliance to the house vent, helping maintain proper airflow and reduce back-drafting. Designed to fit compatible Bosch ventilation assemblies. What it does:

• Routes exhaust air from the appliance to the home vent or hood exhaust system.
• Replaces damaged, bent, or disconnected ducting that can restrict airflow.
• Helps reduce odors and heat buildup by restoring a clear exhaust pathway.
• Works as a direct replacement part where the OEM duct is specified.

• One ventilation duct/duct connector as shown.

• Turn off power to the appliance and ensure the unit is cool before servicing.
• Inspect surrounding seals and fasteners; replace any damaged clamps or gaskets separately.
• Slide or fasten the duct into place and secure with appropriate clamps; ensure a tight, unobstructed path.

Replace your dishwasher's front cabinet trim frame if cracked, broken, or missing. Restores clean appearance and secures control panel alignment.

Replace your dishwasher door gasket when leaks appear or the seal feels hard and cracked. Restores watertight sealing. Confirm fit with your model number.